User manual KENWOOD LS-K711

[. . . ] Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to these model and serial numbers whenever you call upon your KENWOOD dealer for information or service on this product. Products with the symbol (crossed-out wheeled bin) cannot be disposed as household waste. [. . . ] contact your local authority for details in locating a recycle facility nearest to you. Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on our health and the environment. Place the left and right speakers at each side of your TV. Angle the speakers towards the listening area to enhance the stereo effect. â· Place the center speaker on the center between the front left and right speakers. The subwoofer's deep-bass reproduction characteristics are richest when the subwoofer is installed in a corner or near a wall. â· Place the surround speakers straight to or diagonally behind the left and right of the listening position. â· Place the surround back speaker behind the listining position, at the same height as the left and right surround speakers. Caution: Read this item carefully to keep your safety. To ensure safe and reliable operation, be sure that your amplifier or receiver (audio video control center) is able to work with 8-ohm speaker. To avoid speaker damage, never run the speakers at power levels exceeding this limit. Wire with white line The speaker wire can also be connected to the speaker by using banana plugs which are commercially available in audio stores. To use the banana plug connection, tighten the screws on the speaker terminals before inserting the banana plug. To prevent the speaker from toppling down, the speaker should be placed on its side before connection. Lay the speaker gently and pass the speaker wire through the hole on the base. Wire with white line Wire with white line When using the speaker as the surround back speaker, connect the speaker wire to the surround back speaker output terminals. This speaker is capable of bi-wiring connection, with which the woofer and midrange/tweeter units can be driven independently. To connect each speaker in the bi-wiring connection, prepare two speaker wires (commercially available) and connect them as shown below. [. . . ] To connect each speaker in the bi-wiring connection, prepare two speaker wires (commercially available) and connect them as shown below. The lower pair of speaker terminals is used to connect the woofer, and the upper pair is used to connect the midrange/ tweeter. When distributing the speaker wires through the hole on the base, see "Lay the speaker wire. [. . . ]