User manual KENWOOD LS-X70

[. . . ] It will help you to obtain the peak performance for which the speakers were designed. Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to these model and serial numbers whenever you call upon your KENWOOD dealer for information or service on this product. [. . . ] Refer to these model and serial numbers whenever you call upon your KENWOOD dealer for information or service on this product. Caution: Read this item carefully to keep your safety. Suffocation ­ After taking the unit out of the polyethylene bag, be sure to dispose of the polyethylene bag out of the reach of children. Otherwise, they may play with the bag, which could cause hazard of suffocation. Water and moisture ­ The appliance should not be used near water - for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. Heat ­ Do not install the unit near a source of heat, such as radiators, or under direct sunlight. Modification ­ Do not attempt to open or modify the unit, for this could cause fire hazard or malfunction. Cleaning ­ Do not use volatile solvents such as alcohol, paint thinner, gasoline, or benzine, etc. Be sure to use screws that are appropriate for the wall you are using, and that are long enough to provide sufficient strength. ⷠIf you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this type of installation, please consult a contractor or other qualified person before proceeding. Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient support strength. The speaker can be installed on the SR-8000 stand optionally available from KENWOOD. The cushions prevent the speaker from sliding, and dampen its vibrations. The speaker wires and labels of speakers' back panel are color-coded to facilitate connection. connect each wire to the matchingcolored terminal , as shown in the figure. [. . . ] The speaker wires and labels of speakers' back panel are color-coded to facilitate connection. connect each wire to the matchingcolored terminal , as shown in the figure. Be sure to turn off your amplifier before connecting or disconnecting speakers. [. . . ]