User manual KENWOOD LZ-700W

[. . . ] The unit returns to factory settings when the Reset button is pressed. When the temperature of the unit falls such as during winter, the liquid crystal panel's screen will become darker than usual. Products with the symbol (crossed-out wheeled bin) cannot be disposed as household waste. Old electrical and electronic equipment should be recycled at a facility capable of handling these items and their waste byproducts. [. . . ] Turning OFF the Power Press the [SCRN] button for at least 1 second. Each time the button is pressed, the screen mode switches as follows: Display "Full" Setting Full picture mode. You can select the IR Headphones audio you wish. press the [MODE] button for at least 1 second. Each time the button is pressed for at least 1 second, the audio input switches as follows: Display "Normal" "AV-IN1" "AV-IN2" "Off" Setting Sound with monitor source. Item "BRT" "TIN" "COL" "CONT" "BLK" Button [3] [2] [3] [2] [3] [2] [3] [2] [3] [2] Setting Brighter screen Darker screen Stronger red level Stronger green level Deeper color Paler color Stronger contrast Less contrast Less black level Stronger black level Turn off the headphones before changing the <IR Headphones audio setting>. When it gets dark, the brightness of display lowers automatically. You can set the display off mode for the monitor. Exit the Display off mode Press any button. The "BRT" can be adjusted when "Auto DIM" is set to "Off". The "TIN" can be adjusted when NTSC video signal is input. Do not let unconnected wires or terminals touch metal on the car or anything else conducting electricity. To prevent short circuits do not remove the caps from unused terminals or from the ends of the unconnected wires. After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. Insulate unconnected wires with vinyl tape or other similar material. Thoroughly wipe away oil and other dirt from the installation surface. Otherwise heat build-up occurs and the unit may be damaged. For safety's sake, leave the mounting and wiring work to professionals. Using the supplied paper pattern (Accessory 5), mark the area to be cut out of the headrest, then carefully cut it. Use screws (Accessory 3) to fix Hideaway Unit onto an audio board or another. What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. [. . . ] Select the transmitter frequency according to your headphones. The headphones power switch is turned on. 2 Pull the monitor unit all the way out with your Hands, being careful not to drop it. Specifications subject to change without notice. [. . . ]