User manual KENWOOD LZ-702W

[. . . ] Using a fuse with the wrong rating may cause your unit to malfunction. If you use the wrong screws, you could damage the unit. You cannot view video pictures whilst the vehicle is moving. To enjoy video pictures, find a safe place to park and engage the parking brake. [. . . ] SEL] button when the image from the navigation unit connected to "TO NAVIGATION" terminal is shown on the monitor. SEL] button when the image from the navigation unit connected to "AV1 INPUT" terminal is shown on the monitor. Use this setting when there's nothing connected to the navigation unit. Item Touch "Reverse" [7On] Setting Switches to the rear view camera video display when engaging the shift knob of car to "Reverse". Switches to the rear view camera video display when engaging the shift knob of car to "Reverse" and then pressing the [V. The image which appeares in the camera is turned left-side right and displayed. Touch the [Yes] button, restores the factory set default values for individual items from those set by the user. You can select the built-in speaker mode you wish. The touch panel can be adjusted if the position touched and the operation performed do not match. 1 Accurately touch the mark at the lower left. If the [Cancel] button is touched without touching the button at the lower left, the adjustment is canceled and the screen goes back to the Setup Menu Screen. If the [Cancel] button is touched after touching the button at the lower left, the button at the lower left reappears. If the [Reset] button is touched, the settings are reset to the factory defaults and the setup menu screen reappears. To prevent short circuits, remove the key from the ignition and disconnect the · Make the proper input and output cable connections for each unit. Connect the wiring harness wires in the following order: ground, ignition. This product is intended for use with 12V DC negative ground power only. Do not connect it to any other power supply. To prevent shorting, disconnect the battery cable from the negative terminal of the battery during installation. Be sure to firmly stabilise this product. Do not install it in a location which is not stable. Follow the installation and wiring procedures described in this manual. Improper wiring or modified installation can not only result in malfunction or damage to the unit but may also result in an accident. [. . . ] After checking for short circuits in the wires, replace the fuse with one with the same rating. Nothing happens when the buttons are pressed. The computer chip in the unit is not functioning normally. The unit is in a location where temperature is low. [. . . ]