User manual KENWOOD LZH-100W

[. . . ] the monitor screen must not be visible to the driver. Viewing by the driver while operating the vehicle will create an unsafe condition. ⷠKenwood does not recommend connecting hanging wires or cables to auxiliary connectors while the vehicle is in motion. [. . . ] ⷠKenwood does not recommend connecting hanging wires or cables to auxiliary connectors while the vehicle is in motion. ⷠThis product must not obstruct the driver's rear view when installed or used. ⷠIt is the responsibility of the purchaser and installer to comply with all applicable laws and regulations governing the installation and use of this product. ⷠKenwood disclaims all liability for any property damage or personal injury that may result from improper or unintended installation or use of this product. Your LZH-100W console lets rear-seat passengers enjoy audio/video entertainment from its 7" TV screen and wired & wireless headphone outputs. these instructions contain instructions for installing the LZH-100W safely in a vehicle. For the latest information about this and other Kenwood products, visit the Kenwood Corporation Web site at: www. Unpack your LZH-100W carefully and make sure that everything listed here is present: If anything is missing or damaged, or if your LZH-100W fails to operate, notify your dealer immediately. B) Using the marks on the roof as a guide, hold the console against the mounting bracket in the mounting location. c) Mark the console's mounting screw hole locations on the bracket and drill pilot holes. D) Make sure screws are the correct length to avoid damaging the vehicle roof. Route all wiring harnesses through the vehicle and through the access hole in the headliner. ⷠRoute the wiring so there is no excess at the console mounting location or above the headliner. Start from the centre of the roof and work out towards the sides, front, and rear. With all of the vehicle doors closed and the lights off, place the probes of a volt meter on the vehicle's dome light wires: a) If the meter shows 0 V, the vehicle has a Positive Switched system. Green wire --> vehicle's switched dome light wire a good earth point on the vehicle · Green wire --> vehicle's switched dome light wire a fused constant 12 V source · Feed all slack through the hole in the headliner; Don't Allow the slack to bunch up & cause lumps in the headliner. [. . . ] With all of the vehicle doors closed and the lights off, place the probes of a volt meter on the vehicle's dome light wires: a) If the meter shows 0 V, the vehicle has a Positive Switched system. Green wire --> vehicle's switched dome light wire a good earth point on the vehicle · Green wire --> vehicle's switched dome light wire a fused constant 12 V source · Feed all slack through the hole in the headliner; Don't Allow the slack to bunch up & cause lumps in the headliner. ⷠLeave a slight amount of slack behind the console to allow it to be easily disassembled if necessary. [. . . ]