User manual KENWOOD NX-411

[. . . ] contact your local authority for details in locating a recycle facility nearest to you. Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on our health and the environment. Notice: The sign "Pb" below the symbol for batteries indicates that this battery contains lead. We are grateful you have chosen Kenwood for your land mobile radio applications. [. . . ] When using an option with the transceiver, ensure that it corresponds with the IP67 standard. Extreme heat, deteriorate, or cause other forms of damage to the battery. The battery pack has a safety function and protection circuit to avoid danger. If they suffer serious damage, the battery may Do not short-circuit the battery!Do not join the + and ­ terminals using any form of metal (such as a paper clip or wire). Do not carry or store the battery pack in containers holding metal objects (such as wires, chainnecklace or hairpins). If the battery pack is short-circuited, objects to heat up. Do not incinerate or apply heat to the battery!If the insulator is melted, the gas release vent or safety function is damaged, or the electrolyte is ignited, the battery may Do not use or leave the battery near fires, stoves, or other heat generators (areas reaching over 80°C/ 176°F)!If the polymer separator is melted due to high temperature, an internal short-circuit may occur in the individual cells and the battery may generate heat or smoke, rupture, or burst into Avoid immersing the battery in water or getting it wet by other means!If the battery becomes wet, wipe it off with a dry towel before use. The battery may generate heat or smoke, rupture, or If any items are missing or Note: These unpacking instructions are for use by your Kenwood dealer, an authorized Kenwood service facility, or the factory. Lock the safety catch to prevent accidentally releasing the battery pack. To remove the battery pack, lift the safety catch, press the release latch, then pull the transceiver. note: For battery pack charging procedures and useage , refer to the battery charger Instruction Manual. Before charging a battery pack that is attached to the While operating the transceiver using a Li-ion battery pack in operating time may be shortened. Connector on the top of the transceiver by holding the antenna at its base and turning Note: If the belt clip is not installed, its mounting location may get hot during continuous a hot environment. Glues, may crack the transceiver's back panel. Insert the cap into place over the universal connector and secure it in place using the attached Auxiliary key Transmit/ Receive/ Battery low indicator Auxiliary key Transmit/ Receive/ Battery low indicator These keys can a programmable function key is programmed as "Function". Key key key Can be programmed only on the Selector knob. Can be programmed only on the microphone programmable function keys. Can be programmed only on the Selector knob. [. . . ] Respond to the call by pressing the PTT speaking into the microphone. Select "ALL" Fleet and "ALL" ID to make a call to all units Be decided in your talk group. transmitting 1 Select your desired zone and channel. 2 Press the key programmed as Status to enter Status Selcall + Status to enter 3 Press ⷠIf Manual Dialing is enabled, you can enter a station ID by using the DTMF keypad, or by using . [. . . ]