User manual KENWOOD NX-720HG

[. . . ] 6 V ±15% Ground High Impedance Ground 600  High Impedance High Impedance RF Antenna Terminal 50  impedance GPS Antenna Terminal <NX-720HG/ NX-820HG/ NX-920G only> 50  impedance THANK YOU We are grateful you have chosen KENWOOD for your personal mobile applications. This instruction manual covers only the basic operations of your mobile radio. Ask your dealer for information on any customized features they may have added to your radio. NOTICES TO THE USER ◆ Government law prohibits the operation of unlicensed transmitters within the territories under government control. [. . . ] ■ Identification Codes An ID code is a combination of a 3-digit Fleet number and a 4-digit ID number. €¢ Enter a Fleet number (100 ~ 349) to make a group call. €¢ Enter an ID number (1000 ~ 4999) to make an individual call in your fleet. €¢ Enter a Fleet number to make a call to all units in the selected fleet (Fleet call). STATUS MESSAGE You can send and receive 2-digit Status messages which may be decided in your talk group. messages can contain up to 16 alphanumeric characters. Status messages range from 10 to 99 (80 ~ 99 are reserved for special messages). A maximum of 15 received messages (combined status messages and short messages) can be stored in the stack memory of your transceiver. Press the / key to select the station you want to call. €¢ If Manual Dialing is enabled, you can enter a station ID by using the microphone DTMF keypad by pressing and holding the S or key. Repeat this process until the entire ID is entered. Press the S or key to enter Status mode. 4 10 5 6 Press the / key to select the status you want to transmit. €¢ If Manual Dialing is enabled, you can enter a station ID by using the microphone DTMF keypad (refer to step 3, above). Press the PTT switch to initiate the call. €¢ “COMPLETE” appears on the display when the status has been successfully transmitted. –  Receiving A calling ID or text message will appear when a Status call is received. Press any key to return to normal operation. –  Reviewing Messages in the Stack Memory 1 Press the key programmed as [Stack], or press and hold the key programmed as [Selcall], [Status], or [Selcall + Status] to enter Stack mode. • The last received message is displayed. 2 Press the / key to select the desired message. €¢ Message types are identified as follows: ID: Caller ID, ST: Status Message, ME: Short Message • Press and hold the S or key for 1 second to cycle the display information as follows: ID Name > Status/Short Message > CH/GID 3 Press the key to return to normal operation. [. . . ] €¢ The icon momentarily appears on the display when Horn Alert is active. EXTERNAL SPEAKER When attaching an external speaker to the transceiver via the KCT-60, press the key programmed as [External Speaker] to output all received signals through the external speaker. • The icon appears on the display. Press the [External Speaker] key again to output all received signals only through the built-in speaker. [. . . ]