User manual KENWOOD PROSPER+ KHC29.H0WH

[. . . ] O Read these instructions carefully and retain for future reference. O If the plug or cord is damaged it must, for safety Reasons, be replaced by Kenwood or an authorised Kenwood repairer in order to avoid a hazard. O Turn the speed control to `O' (OFF) position and unplug: O before fitting or removing outlet covers/tools/ Attachments; O after and when not in use; O before cleaning. O Do not operate your appliance for longer than the times specified below without a rest period. [. . . ] Raise the mixer head and whilst holding it steady, pull the tool from the outlet. hints and Tips Beater O When creaming fat and sugar for Cake mixes, always use the fat at room temperature or soften it first. O Switch off and scrape the bowl with a spatula when necessary. O Use cold ingredients for pastry unless your recipe states otherwise. Dough hook O The ingredients mix best if you put the liquid in first. O At intervals stop the machine and scrape the mixture off the dough hook. The stickiness of the dough has a direct effect on the load on the machine. Keep the machine under observation whilst the dough is mixing. Whisk Important O Do not use the whisk for heavy mixtures e. Creaming fat and sugar as you will damage it. O Best results achieved when eggs are at room temperature. O Before whisking egg whites, make sure there is no grease or egg yolk on the whisk or the bowl. o M ayonnaise - for best results Scrape down the bowl after the addition of the oil and run for a further 10 secs at max speed. O B atter Mixes - add the flour to the bowl first, then liquid and mix on minimum speed to incorporate the ingredients. electronic Speed Sensor Control Your mixer is fitted with an electronic speed sensor control that is designed to maintain the speed under different load conditions, such as when kneading bread dough or when eggs are added to a cake mix. You may therefore hear some variation in speed during the operation as the mixer adjusts to the load and speed selected - this is normal. O If the mixer head is raised during operation, the machine will continue to operate. Always switch off before raising the head. O The machine will not operate unless all the outlet covers are correctly fitted. O If you hear the machine labouring either switch off and remove some of the mixture or increase the speed. o Your mixer has been fitted with a `soft start' feature to minimise spillage. However if the machine is switched on with a heavy mixture in the bowl such as bread dough, you may notice that the mixer takes a few seconds to reach the selected speed. [. . . ] Leaking will occur if the seal is not fitted correctly. 4 Screw the base onto the jar until it is finger-tight. 5 Place the mill onto the outlet with the arrow on the mill base towards the back of the machine. Turn the mill clockwise to lock firmly into place until the two arrows align . [. . . ]