Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual KENWOOD R-SE9T. We hope that this KENWOOD R-SE9T user guide will be useful to you.
Lastmanuals help download the user guide KENWOOD R-SE9T.
Detailed instructions for use are in the User's Guide.
[. . . ] FM/AM RECEIVER
R-SE9T DP-SE9 X-SE9
CD PLAYER CASSETTE TAPE DECK
INSTRUCTION MANUAL
KENWOOD CORPORATION
COMPACT
DIGITAL AUDIO
B60-3715-00 JA (T) AP AP WS DT 98/12 11 10 9 8 7 6 5 4 3 2 1 97/12 11 10 9 8 7 6 5
2
Before applying power
Caution : Read this page carefully toBefore applying power ensure safe operation.
R-SE9T/DP-SE9/X-SE9 (En)
Units are designed for operation as follows. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . and Canada . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 120 V only
For the United Kingdom
Factory fitted moulded mains plug
1. The mains plug contains a fuse. [. . . ] 1"AUTO" lit (Auto tuning) 2"AUTO" not lit (Manual tuning)
FM
8 8 . ) )
MHz
Application section
"TUNING" appears (for approx. 5 sec. ) R-SE9T
TUNING
Lights during stereo reception
AUTO ST. TUNED
Use the manual tuning mode when reception is noisy due to weak reception. (In the manual mode, stereo broadcasts are received in monaural. )
Frequency display R-SE9T
÷ Normally, use the AUTO (Auto tuning) mode.
FM
8 9 . ) )
About display change during tuner reception
MHz
The "TUNED" indicator lights when a station is received. ÷ When a key is held depressed, preset stations will be skipped at an interval of about 0. 5 second. ÷ Preset calls also can be made by numerical input via the numeric keys on the remote control. When the key for the tens digit has been pressed erroneously at the time of input, press the +10 key several times to return to the original display and then enter the number again.
The display will change each time the DISPLAY key is pressed. 1Reception band/Frequency 2Preset number/Frequency 3Clock The display will change each time the RDS DISPLAY key is pressed. 1 PS (Program Service Name) Display 2Reception band/Frequency
Knowledge sections
28
Recording
Note
Recording
R-SE9T/DP-SE9/X-SE9 (En)
Recording
Note that this cassette deck cannot record onto Metal tapes.
4
Preparation section
3 3
1 5
2
Basic section
0
1. Load a tape in deck.
Top side
1
1 Open the tray of the cassette deck. 3 Close the tray.
÷ Differentiation between normal (TYPE I) and high (TYPE II) tape is set automatically. ÷ Remove tape slack before loading.
Application section
Reverse side
Check the tape transport direction indicator.
2. Select the tape transport direction.
To reverse the transport direction 1 Press the playback key for the direction to be played (lights green). 2 Stop playback (lights red).
÷ When recording is started, the tape is transported in the direction selected in this step. ÷ Wind the tape to the position where recording is to be started.
2
Knowledge sections
3
Dolby NR
rev. Set the recording condition.
3
3
1 Select the reverse mode. 2 Select the DOLBY NR mode.
£ £
Recording
29
R-SE9T/DP-SE9/X-SE9 (En)
Temporary stop during recording
8
8
An unrecorded section of about 4 sec is produced (auto recording mute)
1 Obtain stop condition. 2 Press the record key twice.
About 4 sec
¶
8
¶
÷ Press the record key to restart recording.
¶ ¶
To interrupt recording
An unrecorded section of about 4 sec is produced directly after the recording has been interrupted.
8
¶
Preparation section
÷ An unrecorded section of about 4 sec is produced and recording pause condition is reached.
To end recording
7
¶ ¶
÷ Recording pause condition is reached after approximately 4 sec.
Basic section
4. Select the source to be recorded.
multi control
The input source component to be recorded should be displayed. R-SE9T
4
Select an input source other than "TAPE" input.
CD
÷ When the CD input is selected and if a disc has been set in the CD player, its playback starts immediately.
Application section
5. Start recording.
¶
5
1 Play (or tune) the input source to be recorded. 2 Start recording.
Lights
¶
÷ The recording level is adjusted automatically when the CRLS function is used. [. . . ] 1 Motors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Wow and flutter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 1 % (W. R. M. S. ) Fast winding time . . . . . . . . . . . . . . . . . . . . . . 110 seconds (C-60 tape) Frequency response TYPE I tape . . . . . . . . . . . . . . . . . . . . [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE KENWOOD R-SE9T
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual KENWOOD R-SE9T will begin.