User manual KENWOOD SK650

[. . . ] Warning: Do not open the lid while the water is boiling. Take care when opening the lid droplets of hot water may be ejected. Make sure the kettle is switched off before lifting or pouring. Remove the kettle from the base before filling or pouring. [. . . ] the inside Even though your kettle comes with a filter, you still need to clean the inside (and the filter) regularly. to use your kettle 1 Fill the kettle through either the spout or by removing the lid. The water level must be between `MAX' and `MIN'. Be economical: do not boil more water than you need. To improve the quality of your drinks always use fresh water. 4 Your kettle will boil and switch off automatically. To re-boil, wait a few seconds - the on/off switch needs time to reset. If you experience problems with your kettle switching on and off during use or switching off before boiling, check that the flat element is free from scale - see "descaling". Your kettle is fitted with a filter to hold back limescale particles. If you find drops of water under your kettle, don't worry - it is just condensation. the filter 1 Remove the lid. 3 either rinse under the tap or use a soft brush. or when descaling your kettle, drop the filter in too. 4 Slide the filter back in to refit. Note: For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service). If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet. descaling Regular descaling of the flat element will improve the performance of your kettle. If the kettle is not descaled regularly the build up of limescale may result in the following: problems may be experienced with the kettle switching on and off during use or switching off before boiling. the flat element may be damaged. Please note: Failure to descale your kettle may invalidate your guarantee. When limescale starts to build up on the heating element, buy a suitable descaler and descale your kettle. After descaling, boil with fresh water several times and discard. [. . . ] Keep children away from the kitchen work area. For baby's bath, run the cold water first, then add the hot. Mix well and test the temperature with your elbow before you put baby in. run cold water over a burn immediately, then get medical help. [. . . ]