User manual KENWOOD TS-570DG PARTS LIST

[. . . ] You may need to repack the transceiver in the future. This equipment generates or uses radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC Accessory Microphone DC power cable 7-pin DIN plug 13-pin DIN plug Fuse (25 A) Fuse (4 A) Instruction manual Schematic/block diagrams1 (U. S. A. and Canada only) Warranty card (U. S. A. , Canada, and Europe only) 1 For Part Number T91-0352-XX E30-3157-XX E07-0751-XX E07-1351-XX F05-2531-XX F06-4027-XX B62-1542-XX -- Quantity 1 1 1 1 1 1 1 1 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] You can select from five different transmit profiles including the default flat response . Selecting any of the following items from the Menu causes "TX EQ. " to appear on the display. · High boost (Hb): Emphasizes higher audio frequencies; effective for a bassy voice. · Formant pass (FP): Improves clarity by suppressing audio frequencies outside the normal voice frequency range. · Bass boost (bb): Emphasizes lower audio frequencies; effective for a voice with more high frequency components. · Conventional (c): Emphasizes by 3 dB frequencies at 600 Hz and higher. Amplitude Conventional Formant pass High boost Off Bass boost TRANSMIT INHIBIT Transmit Inhibit prevents the transceiver from being placed in the transmit mode. No signals can be transmitted if this function is ON. · · TX Inhibit OFF: Transmissions are possible. TX Inhibit ON: Transmissions are not possible. Switch the function ON or OFF via Menu No. The default is OFF. CHANGING FREQUENCY WHILE TRANSMITTING Moving your frequency while transmitting is usually an unwise practice due to the risk of interference to other stations. However, if necessary, by using the Tuning control you can change the operating frequency while transmitting. When Full is selected: The transceiver immediately switches to the receive mode when the key opens. When a delay time is selected: The transceiver switches to the receive mode after the delay time that you have selected has passed. 3 While keying the paddle and listening to the transmit sidetone, turn the MULTI/CH control to select the appropriate speed. · The selectable range is 0 to 100 in steps of 2. The larger the number, the faster the speed. 4 Press [KEY] again to complete the setting. Note: When using the semi-automatic "Bug" function, the selected speed applies only to the rate that dots are sent. 5 Begin sending. · · AUTO WEIGHTING The electronic keyer can automatically change the dot/ dash weighting. Weighting is the ratio of dash length to dot length. The weighting changes with your keying speed thus making your keying easier for other operators to copy. When Auto Weighting is OFF, the weighting is locked at 3:1. Reversible Auto Weighting Auto Weighting increases the weighting as you increase your keying speed. However, the electronic keyer also can decrease the weighting as you increase your keying speed. To switch this function ON, access Menu No. [. . . ] 26 RX Equalizer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Satellite Operation. . . . . . . . . . . . . . . . . . . . . . . 28 Scan Carrier-operated . . . . . . . . . . . . . . . . . . . . . 47 Hold . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]