User manual KENWOOD VR-507

[. . . ] AUDIO VIDEO SURROUND RECEIVER VR-507 KRF-V7050D INSTRUCTION MANUAL KENWOOD CORPORATION This instruction manual is used to describe multiple models listed above. Model availability and features (functions) may differ depending on the country and sales area. About the supplied remote control Compared to standard remote controls, the remote control supplied with this receiver has several operation modes. These modes enable the remote control to control other audio/video components. In order to effectively use the remote control it is important to read the operating instructions and obtain a proper understanding of the remote control and how to switch its operation modes (etc. ). [. . . ] (Press the SOUND key twice. ) SP A B TI. VOL CLIP MUTE RDS EON PTY TP TA NEWS 2 Start playback from the selected source. 3 Use the VOLUME CONTROL knob or VOLUME keys to adjust the volume. L LFE C S R SW LS RS FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S. DIRECT MEMO MHz 3 STEREO MONITOR ST. TUNED kHz DOWN MIX DSP 2 Use the MULTI CONTROL knob or keys to adjust the sound quality. · The bass and treble levels are adjustable from -10dB to +10dB in 2 step increments. · The adjustment item is displayed for approximately 8 seconds. Once-touch low frequency emphasis (bass boost) (remote control only) You can adjust the sound quality when the receiver is in the PCM stereo and analog stereo modes. · Press the key once to select the maximum (+10dB) low frequency emphasis setting. · This key does not function when the receiver is in the sound quality or ambience effects adjustment mode. Switching back to the previous setting Press the B. BOOST or BASS BOOST key again. Operations Normal playback Recording Recording audio (analog sources) 22 Muting the sound The MUTE key lets you mute the sound of the speakers. Press the MUTE key. SP A B TI. VOL MUTE CLIP RDS EON PTY TP TA NEWS MONITOR L LFE C S R SW LS RS To cancel Blinks INPUT SELECTOR Press the MUTE key again so that the "MUTE" indicator goes off. · MUTE ON can also be deactivated by turning the volume control knob. Recording a music source 1 Use the INPUT SELECTOR knob to select the source (other than "MD/TAPE") you want to record. 2 Set the cassette deck or MD recorder to record. 3 Start playback, then start recording. SOURCE DIRECT playback (for analog input sources only) Use this function to pass the source material direct to the amplifier, bypassing any audio processing. Press the SOURCE DIRECT key. FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S. DIRECT MEMO MHz 3 STEREO MONITOR ST. TUNED kHz DOWN MIX DSP Recording tapes or MD (with MONITOR function) MONITOR = MD/TAPE recording 1 Press the MONITOR key. FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S. DIRECT MEMO MHz 3 STEREO MONITOR ST. TUNED kHz DOWN MIX DSP · When you press the LISTEN MODE, SOUND, or SET UP keys, or switch to another input source, SOURCE DIRECT playback will be canceled. is switched ON, SOURCE DIRECT key will not be effective. · If SOURCE DIRECT is switched ON, CINEMA EQ. function will not be effective. Operations 2 Use the INPUT SELECTOR knob to select a source other than "MD/TAPE". 3 Start playback on the cassette deck connected to the MONITOR jacks and start recording on the cassette deck or MD recorder connected to the MD/TAPE jacks. MD/TAPE = MONITOR recording 1 Use the INPUT SELECTOR knob to select "MD/TAPE. " 2 Start playback on the cassette deck connected to the MD/TAPE jacks and start recording on the cassette deck or MD recorder connected to the MONITOR jacks. · To copy tapes using a double cassette deck, refer to the instruction manual of the double cassette deck. To cancel Press the SOURCE DIRECT key again. · If SOURCE DIRECT playback was activated while in surround mode, canceling SOURCE DIRECT playback will reactivate the previous surround mode. Listening with headphones 1 Press the SPEAKERS A or B key so that the speaker indicator goes off. [. . . ] 200 mV / 47 k DVD/6CH INPUT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 mV / 10 k Output level / impedance TAPE REC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 mV / 1 k MONITOR OUT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 mV / 1 k PRE OUT (SUBWOOFER) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]