User manual KENWOOD VR-7080A

[. . . ] Using the remote control without completely understanding its design and how to switch the operation modes may result in incorrect operations. B60-5337-00 00 ID (K, P, M, X) 0211 Before applying the power Units are designed for operation as follows. and Canada . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 120 V only Australia . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Distance to front speakers : ____ feet (meters) Distance to center speaker : ____ feet (meters) Distance to surround speakers : ____ feet (meters) 3 Use the MULTI CONTROL knob or keys to select the distance to the front speakers. The speaker indicator to be adjusted blinks. · If subwoofer is turned OFF, subwoofer re-mix setting is not visible. @ Use the MULTI CONTROL knob or keys to select the appropriate subwoofer re-mix setting. 1 RMX ON : Subwoofer re-mix set mode to the receiver is ON. 2 RMX OFF : Subwoofer re-mix set mode to the receiver is OFF. # Press the SETUP key to accept the setting. · The receiver enters the speaker volume level adjustment mode. · In step 4 and 5, indications appear only for the selected channels of the speakers that require adjusting. Indication in feet Indication in meters · The allowable setting range is 1 to 30 feet (0. 3m to 9. 0m) , adjustable in 1 foot (0. 3m) increments. 4 Press the SETUP key to accept the settings. 5 Repeat steps 3 and 4 to input the distance for each of the speakers. 6 Setup is complete when the EXIT indication appears. 4Adjust the speaker volume level. From your usual listening position, adjust the volume levels. The adjustment can be made when the receiver is in the PCM stereo and analog stereo mode. Press the LOUDNESS key to turn the LOUDNESS setting ON. To cancel Press the LOUDNESS key again so that the "LOUDNESS" indicator goes off. PHONES MULTI CONTROL MUTE Muting the sound The MUTE key lets you mute the sound of the speakers. Press the MUTE key. BASS BOOST MUTE LOUDNESS MULTI CONTROL ACTIVE EQ TONE VOLUME To cancel Press the MUTE key again so that the "MUTE" indicator goes off. · MUTE ON can also be deactivated by turning the volume control knob. Adjusting the TONE (remote control only) You can adjust the sound quality when the receiver is in the PCM stereo and analog stereo mode. 1 Press the TONE key to select the TONE mode. 2 Use the MULTI CONTROL knob or keys to select TONE ON/OFF. ACTIVE EQ mode You can enjoy a more impressive sound effect when ACTIVE EQ is turned ON during Dolby Digital and DTS playback and, when in PCM and analog stereo mode Press the ACTIVE EQ key for the following selections; 1 ACTIVE EQ MUSIC : Effective when listening to music. (The ACTIVE EQ LED indicator lights up. ) 2 ACTIVE EQ CINEMA : Effective when watching a movie. (The ACTIVE EQ LED indicator lights up. ) 3 ACTIVE EQ TV : Effective when watching TV. (The ACTIVE EQ LED indicator lights up. ) 4 ACTIVE EQ OFF : The ACTIVE EQ function is turned OFF. (The ACTIVE EQ LED indicator goes off. ) · ACTIVE EQ function will not be available when REC MODE, AUTO TUNING or PRESET MEMORY is ON and during 96kHz LPCM playback. 3 When in TONE ON selection, press the TONE key for the following displays. BASS : Select this to adjust the low frequency range. [. . . ] 550 mV / 10 k Output level / impedance TAPE REC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 550 mV / 1 k PRE OUT (SUBWOOFER) (KRF-V5070D) . . . . . . . . . . . . . 1. 5 V / 2. 2 k Tone control BASS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±10 dB (at 100 Hz) TREBLE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]