User manual KENWOOD XR-S17P

[. . . ] ⷠTo prevent short-circuit, keep all wiring away from moving parts, sharp edges, cut metal, etc. ⷠWhen removing or installing the grille, be careful not to brush the unit with the edge of the grille. ⷠDo not switch ON power until wiring is completed. [. . . ] ⷠDo not switch ON power until wiring is completed. Note : For mounting location, do not select the following places. door panel · When the door window glass is lowered (opened), the unit is damaged. ⷠWhen the window crank handle is rotated, it comes into contact with the unit. rear deck · When the unit comes into contact with the boot lid spring (trunk lid spring) or shock absorbers (shock towers). ⷠWhen the unit damages the gas tank or fuel hose. ⷠWhen the unit comes into contact with the rear window glass, car wall, etc. Information on Disposal of Old Electrical and Electronic Equipment (applicable for EU countries that have adopted separate waste collection systems) Products with the symbol (crossed-out wheeled bin) cannot be disposed as household waste. With this unit, the speaker cords are not supplied. obtain the audio speaker cords with the required length. To connect the speaker cords to the unit, terminate the wires with female spade connectors. Note: When using the speaker as a Three-way speaker combined with a sub woofer connect nonpolar capacitors in series (with voltage resistance greater than 63V and capacitance less than 270F) as H. Large power input will cause the protection circuit for the tweeter to operate, which will decrease output level. In this case, turn the volume of the receiver to "0", then eventually the tweeter will automatically start working again. Using the crossover network in high temperature (under direct sunlight) may cause the protection circuit to operate easily. Do not install in places under direct sunlight. [. . . ] Using the crossover network in high temperature (under direct sunlight) may cause the protection circuit to operate easily. Do not install in places under direct sunlight. ⷠDo not touch the electronic parts inside the crossover network. [. . . ]