User manual KENWOOD ZJG111CL

[. . . ] Caution: Do not operate the kettle on an inclined surface. Only use the powerbase supplied and keep it clean and dry. Make sure the lid is secure before switching the kettle on. ¡UL∞« ÊUOK¨ ¡UM£√ ÍuKF∞« ¡UDG∞« w∫∑H¢ ô :d¥c∫¢ 107 W±öº∞« G G G G G G G G G G G G G G G G G G G G G G G G G Warning: Do not open the lid while the water is boiling. [. . . ] Even though your kettle comes with a filter, you still need to clean the inside (and the filter) regularly. G to use your kettle 1 Press the lid release button ቤ to open the lid, then fill the kettle. The water level must be between ‘MAX’ and 1 cup (250mls). G If you live in a hard water area we recommend that you use filtered water in order to maintain the appearance and efficiency of your kettle. G Be economical: do not boil more water than you need. G To improve the quality of your drinks always use fresh water. 2 Close the lid – ensuring it is latched down correctly. To re-boil, wait a few seconds - the on/off switch needs time to reset. 2 Unclip the filter by pushing down on the arrow graphic ᕡ then lift the filter out away from the spout area ᕢ. 3 either rinse under the tap or use a soft brush. Or when descaling your kettle, drop the filter in too. 4 To refit – line the filter up with the spout and slide the filter back into the slot ᕣ, then push forward and clip securely into place. Note: the lid cannot be closed if the filter is not fitted correctly. 4 G descaling Regular descaling of the flat element will improve the performance of your kettle. If the kettle is not descaled regularly the build up of limescale may result in the following: G problems may be experienced with the kettle switching on and off during use or switching off before boiling. Please note: Failure to descale your kettle may invalidate your guarantee. G When limescale starts to build up on the heating element, buy a suitable descaler and descale your kettle. After descaling, boil with fresh water several times and discard. Clean any descaler off the kettle - it can damage the parts. G Some regions of the country have chalky water. This makes boiled water look cloudy and leaves a deposit on the side of the kettle. This is normal but can be removed with regular cleaning. [. . . ] Some regions of the country have chalky water. This makes boiled water look cloudy and leaves a deposit on the side of the kettle. This is normal but can be removed with regular cleaning. If none of the above solve the problem see “Service & Customer Care”. [. . . ]