User manual KETTLER CHAMP 5.0

[. . . ] All KETTLER products are designed in accordance with the latest safety regulations and undergo a constant process of quality control during manufacturing. The knowledge gained in this process is used to constantly improve and develop our products. In order to offer our customers the very best in product quality, we reserve the right to make technical changes at any time. [. . . ] When setting up or dismantling the table, stay clear of its folding radius. When folded up, the table-tennis table presents a large surface to the wind. for this reason , ensure that it is stored in a sheltered position. The table-tennis table may be pushed only into the transport position because there is otherwise a danger of injury. The unit complies with the standard EN 14468­1:2004. depending on frequency of use , check all screws , bolts etc. Regularly to ensure that they are in good condition. I Do not use the table-tennis table until it has been fully and corI For practising without a partner, the table halves can be folded I Ensure that table-tennis tables which are not weatherproof are I For more information on the sport of table-tennis, you are re- Keep them well away from direct sources of heat. Should the surface become warped, lay the table on a level surface for a few days. I Do not cover it with plastic foil, under which condensation may I Do not use corrosive or abrasive materials to clean the equip- Ensure that such materials are not allowed to pollute the environment. Its useful life please dispose of this article correctly and safely (local refuse sites). Reach (Choking hazard - contains small parts). I The fastening material required for each assembly step is shown in I The equipment must be assembled with due care by two adult I Ensure that you have received all the parts required (see check Use the fastening material exactly as instructed. I Bolt all the parts together loosely at first, and check that they Should you have any cause for complaint, please contact your KETTLER dealer. I Before assembling the equipment, study the drawings carefully And carry out the operations in the order shown by the diagrams. The correct sequence is given in capital letters. [. . . ] When ordering spare parts, always state the full article number, spare-partnumber, the quantity required and the S/N of the product (see spare parts drawing). Important: spare part prices do not include fastening material; if fastening material (bolts, nuts, washers etc. ) is required, this should be clearly stated on the order by adding the words , , with fastening material". [. . . ]