User manual KETTLER CTR1

[. . . ] For this reason, worn or damaged parts should be replaced immediately and the equipment taken out of use until this has been done. –  If the equipment is in regular use, check all its components thoroughly every 1 -2 months. Pay particular attention to the tightness of bolts and nuts. This is particularly true for the attachment of grip strap, running plate and fastening of the handlebar and front tube. [. . . ] Children at play behave unpredictably and dangerous situations may occur for which the manufacturer cannot be held liable. If, in spite of this, children are allowed to use the equipment, ensure that they are instructed in its proper use and supervised accordingly. –  The crosstrainer complies with the DIN EN 957 - 1/9, class HA. It is therefore suitable for therapeutic use. –  A slight production of noise at the bearing of the centrifugal mass is due to the construction and has no negative effect upon operation. Possibly occurring noise during reverse pedalling result from engineering and are absolutely safe. –  Do not use corrosive or abrasive materials to clean the equipment. Ensure that such materials are not allowed to pollute the environment. –  Please ensure that liquids or perspiration never enter the machine or the electronics. –  Before use, always check all screws and plug-in connections as well as respective safety devices fit correctly. –  Always wear suitable shoes when using. ■ All electric appliances emit electromagnetic radiation when in operation. Please do not leave especially radiation-intensive appliances (e. Mobile telephones) directly next to the cockpit or the electronic controlsystem as otherwise values displayed might be distorted (e. Pulse measurement Instructions for Assembly ■ Ensure that you have received all the parts required (see check list) and that they are undamaged. Should you have any cause for complaint, please contact your KETTLER dealer. –  Before assembling the equipment, study the drawings carefully and carry out the operations in the order shown by the diagrams. The correct sequence is given in capital letters. [. . . ] Tighten the locknuts by hand until resistance is felt, then use spanner to finally tighten nuts completely against resistance (locking device). Then check that all screw connections have been tightened firmly. Attention: once locknuts have been unscrewed they no longer function correctly (the locking device is destroyed), and must be replaced. –  For technical reasons, we reserve the right to carry out preliminary assembly work (e. [. . . ]