User manual KIDDY GUARDIANFIX PRO 2

[. . . ] 10 Securing the child in the age group I (9-18 kg). 11 Securing the child in the age groups II-III (15-36 kg). Dismantling the k-fix after semi-universal use. Introduction kiddy guardianfix pro 2 – operating manual ENG We’re happy that you have decided on the kiddy guardianfix pro 2 as your choice for a child restraint system (A). [. . . ] The maximum reclining position is reached when the seat (I) cannot be pulled forward any further. The maximal angle of the reclining position depends on the position of the Isofix anchorage points in the vehicle. 1 Adjusting the car seat Please familiarise yourself thoroughly with the use of child restraint systems (A) as described in your vehicle’s owner manual. If installation is prevented by a headrest, it must be set at the highest position or removed (Fig. The kiddy guardianfix pro 2’s adjustable backrest (C) ensures that it can rest securely against the backrest of the car seat. 2 Seat for universal installation The kiddy guardianfix pro 2 can also be used in rear-facing car seats that are equipped with a three-point restraint system (Fig. The passenger seat, the seat should be moved to the 8 The child restraint system (A) kiddy guardianfix pro 2 can be installed in vehicles on any seat with a three-point restraint system (Fig. The connectors (E) must be retracted when the kiddy guardianfix pro 2 is installed universal (without k-fix). 3 Seat for semi-universal installation ENG Semi-universal installation of the child restraint system is only possible on car seats fitted with ISOFIX anchors. With the aid of the k-fix connectors, the kiddy guardianfix pro 2 can be securely fastened to the body of the vehicle by using these ISOFIX anchor points. The child restraint system (A) kiddy guardianfix pro 2 can be installed in cars and on seats that are mentioned in the list of approved vehicles. Pdf The manufacturer recommends, if possible, semi-universal installation of the child restraint system (A) with the k-fix connectors. Semi-universal installation in vehicle with k-fix Stick both guide funnels (U) onto the ISOFIX anchor fittings between the seat and backrest of the vehicle seat (Fig. The k-fix connectors (E) will now automatically extend from the back of the seat (I). Test whether the connector hooks are opened by pushing the two release mechanisms (V) forward (Fig. Now press the release button (S) in the front under the leg extension (L) (Fig. When the lock indicators (W) do not show "green", the connector hooks are open (Fig. 9 Now push both k-fix connectors (E) onto the metal brackets (ISOFIX anchor points) and press firmly against it so that the connectors (E) lock in place (Fig. Place the kiddy guardianfix pro 2 on a car seat that allows for semi-universal installation (Section 5. 3) and adjust the car seat if necessary as described in Section 5. ENG The correct locking will be confirmed by the "green" k-fix lock indicator (W) (Fig 19). Test whether the k-fix connectors (E) are closed by jerking on the seat (I) and check the left and right k-fix connector whether the lock indicator (W) shows "green"! [. . . ] 3 Removing the seat cover The leg extension cover is fastened with a rubber band. You can carefully pull the cover off in an upward motion. Afterwards open the poppers respectively Velcro® underneath the leg extension (L) and at the bottom, in the back and on the side of the child safety seat. Remove the strap from the backrest (C) and pull the cover off in an upward motion. [. . . ]