User manual KIDDY SMILEFIX PRO

[. . . ] A front airbag that hits the seat shell with force can cause serious injury or even death to the child!Many injuries are caused by mere thoughtlessness and can easily be avoided. Please read the instructions for use carefully before using the baby seat for the first time. Incorrect use can endanger the life of your child. [. . . ] Let the height adjustment handle (P) click into place again after the headrest (E) has been adjusted. Make sure that the belt system is not twisted or wedged in! The headrest (E) must be adjusted in such a way that the shoulder belts are positioned at the same level as the baby's shoulders (Fig. Make a point off always buckling up your child when it lies in the baby car seat (A)!Now push the safety belt lock tongues (C) into the belt clip (B). It is locked in place when a click sound is heard (Fig. Now pull the centre belt (M) until the belt system fits the body of the child snugly (Fig. Make certain that it is securely locked in place! Place the safety belt lock tongues (C) attached to the shoulder belts over each other (Fig. Place your baby in the baby car seat and then position the shoulder belts (D) over its shoulders (Fig. Now you can take the child out of the seat. Make sure that the belt system is not twisted and does not fit the child's body too tightly. 1 Installation with the vehicle restraint Read up all the necessary information about the use of child restraint systems in your vehicle owner's manual. The kiddy smilefix pro child restraint system can be installed on any seat of vehicles equipped with a 3-point belt system (Fig. * The passenger airbag must be deactivated or another seat must be used. 2 Installation steps with the vehicle restraint Place your kiddy facing the rear on a seat without an active front airbag and with a 3-point belt (Fig. Pull the vehicle restraint out and feed the lap belt through both lap belt guides (K) and press the safety belt lock tongue with a clearly audible click into the belt clip (Fig. Now place the shoulder belt around the baby car seat (A) and feed it through the diagonal belt guide (O) at the rear of the kiddy seat (Fig. Make certain that the belt clip is in the correct position. Some vehicles are fitted with so-called retractor locks. With this the automatic recoiling of the belt can be blocked, which makes a more secure installation of the kiddy seat possible. Read your vehicles' owner manual for more information on this feature or ask your authorised workshop or dealer. [. . . ] After an accident with an impact speed greater than 10 km/h, the child restraint system must be sent back to the manufacturer without fail, to be checked for possible damages and replaced at no charge if deemed necessary. Fabrics: All of our fabrics meet the highest standards regarding colourfastness against UV radiation. nevertheless , all fabrics fade when exposed to UV radiation. This is not due to defective material but to normal wear and tear, which is not covered by the warranty. [. . . ]