User manual KIPOR KGE2000TC

[. . . ] KIPOR POWER CO. , LTD. DIGITAL CONVERTER GENERATOR K G E 2 0 0 0 Tc K G E 2 0 0 0 Ts c PREFACE Thank you for purchasing our generators. This manual covers operation and maintenance of the KGE2000Tc, KGE2000T sc generator. All information in this publication is based on the latest product information available at the time of approval for printing. We reserve the right to make changes at any time without notice and without incurring any obligation. [. . . ] Be sure that all appliances are in good working order before connecting them to the generator. If an appliance begins to operate abnormally, becomes sluggish, or stops suddenly, turn off the generator engine switch immediately. Then disconnect the appliance, and examine it for signs of malfunction. NOTE When an electric motor is started, both the overload indicator light (red) and the output indicator light (green) may go on simultaneously. This is normal if the overload indicator light (red) goes off after about four (4) seconds. If the overload indicator light (red) stays on, consult your generator dealer. 3. In order to acquire both the best effect and the maximum service life of the generator. Usually, the new generator should run 20 hours under 50% load, the generator may reach the best performance. DC application The DC receptacle may be used for charging 12 volt automotive-type batteries only. The zero load voltage is 15V-30V. WARNING The battery gives off explosive gases; keep spark, flames and cigarettes away. Provide adequate ventilation when charging. The battery contains sulfuric acid (electrolyte). Contact with skin or eyes may cause severe burns. Wear protective clothing and a face shield. -If electrolyte gets on your skin, flush with water. -If electrolyte gets in your eyes, flush with water for at least 15 minutes and call a physician. -If swallowed, drink large quantities of water or milk and follow with milk of magnesia or vegetable oil and call a physician. KEEP OUT OF REACH OF CHILDREN. NOTE In DC operation, turn the Smart-throttle switch to the OFF position. Connect the charging cables to the DC receptacle of the generator and then to the battery terminals. Start the engine NOTE The DC receptacle may be used while the AC power is in use. An overloaded DC circuit will trip the DC circuit protector. If this happens, wait a few minutes before pushing in the circuit protector to resume operation. WARNING To prevent the possibility of creating a spark near the battery, connect charging cable first to the generator, then to the battery. Before connecting charging cables to a battery that is installed in a vehicle, disconnect the vehicles grounded battery cable. Reconnect the vehicle's grounded battery cable after the charging cables are removed. [. . . ] Do not smoke or allow flames or sparks in the area. SCREW DRIVER 10. TROUBLESHOOTING When the engine will not start: Is there fuel in the tank?YES Is there a spark from the spark plug?Still no spark Take the generator to an authorized dealer. [. . . ]