User manual KITCHENAID KSW90L0MMR INS

[. . . ] · strainer basket *Silicone caulk/sealant must meet the qualifications of ASTM C920, FDA regulation no. 21, CFR 177. 2600, NSF-51, Dow Corning® 786 is recommended. Countertop requirements This undermount sink is intended to be installed with solid surfaces only. These instructions are intended for use by qualified fabricators and installers only. 2 Installation Instructions. . . · As with all metal objects, follow proper handling techniques. · Freight handling and job site exposure may have damaged the sink. [. . . ] Generously apply aCorning 786silicone bead around continuous the sink rim. Using the 1/4" straight cutter. 060", recess the flange of in bit, opening the sink support by . 050" to to accept sink. NOTE: For reference, 1/16" is . 0625" . Sink 4. Liberally2"apply silicone dabs on plywood sink support at least back from the sink cut-out. (See Figure 3. ) Silicone dabs . 050" / . 060" Silicone Section Detail 1/2" plywood reinforcement sheet Section Detail Figure 3 Figure 2 4. Remove the female template and set aside. Cut out countertop IMPORTANT: All solid surfaces (such as marble and granite) must be cut by a qualified installer or fabricator. 5. Align sink to underside of countertoptopside of the a cut-out so that uniform sink edge is visible from the countertop around the periphery of the cut-out. IMPORTANT: You cannot make any adjustments after performing Step 6, following: 6. Clamp sink supportand solvent totoremove excess a and sink rim countertop. Use non-abrasive cloth silicone that has been squeezed out beyond the cut-out edge. Do not use any metal implements that will scratch the sink. Keep clamps on for a minimum of 24 hours before installing in cabinet. 1. Clamp 1/2" plywood female template on top surface of countertop, in desired position. This position will be determined by the relationship of the sink rim to cabinet gables, cabinet supporting members, and deck mounted fittings. 2. Cut out countertop by tracing edge of female template, using the 1-3/16" router guide bushing and the 1/2" straight cutter bit. 3. Finish cut-out edge of countertop with desired finishing techniques. 4 Use & Care Guide Do routine cleaning Use soap, warm water and sponge. To remove stubborn stains Use any cleaner acceptable for use on stainless steel. Always rub in the direction of the grain. To maintain luster Use a small amount of mineral oil on a soft cloth. Apply evenly to the entire surface of the sink and buff to a shiny finish. Do not use steel wool, scouring pads, steel brushes, etc. Their particles may become embedded in the sink surface and cause a rusty discoloration. They trap water causing iron deposits and surface discoloration. Warranty LIFETIME LIMITED WARRANTY For the lifetime of the product from the date of purchase, when this sink is installed, operated and maintained according to instructions attached to or furnished with the product, KitchenAid will replace sinks found to be defective in materials or workmanship with an equivalent stainless steel sink supplied by KitchenAid. KitchenAid reserves the right to inspect any sink reported to be defective prior to replacement. [. . . ] Write down the information about your sink in the box to the right to better help you obtain assistance or service if you ever need it. Dealer Name ____________________________________ Address _________________________________________ Phone Number __________________________________ Product _________________________________________ Model Number __________________________________ Color and Finish _________________________________ Purchase Date ___________________________________ 5 Requesting Assistance or Service If you need assistance or service in U. S. A. Call the KitchenAid Customer Interaction Center toll-free at 1-800-422-1230. Our consultants are available to assist you. When calling: Please know the purchase date, and the complete model of your sink. [. . . ]