User manual KLIPSCH IMAGE REV A

[. . . ] If you do, do not fully insert the headphones into your ear and listen at a lower volume so you can hear ambient noise. A decibel is a unit of measure of sound, and decibels increase exponentially as sound gets louder. For example, conversational speech is typically around 60dB, and a rock concert in a stadium is often about 110dB. We strongly suggest shorter durations of exposure to loud sounds. [. . . ] There are three sizes of single flange ear gels (small, medium, and large) and two sizes of double flange ear gels (small and large). Beyond fitting the headphone in your ear, the ear gel channels sound and forms a seal in your ear canal that allows the headphone to deliver a full range of audio frequencies. The flanges affect not only fit and comfort, but sound quality as well. Single Flange Ear Gels The single flange ear gels are general purpose gels. Most people will probably prefer these for everyday use. For example, if you 4 Are going to ride a bicycle you should choose a single flange ear gel and wear it very loose in the ear so that you do not block ambient noise, such as other cyclists, cars, or other hazards. Double Flange Ear Gels The double flange ear gels can assist those with harder to fit ears because of their shape. They can also offer a tighter seal (more isolation) for even better acoustic quality, and are more secure in the ear, and may be better suited to physical activity (other than the kind that occurs in traffic). For example, you might choose double flange ear gels if you are a passenger on an airplane and want to block out as much ambient noise as possible. With your thumb and index finger, squeeze the ear gel and pull it off the ear nozzle with a slight twisting action. There is an indicator line on the fitting inside the gel which lines up with an indicator line on the headphone's ear nozzle. Press the ear gel onto the headphone nozzle. The gel locks into place over the nozzle, but still rotates so you can further customize the fit to your ears. Using the steps in the last section, take them for a test listen. Repeat the whole process until you find the gels that fit best. The ear gels and nozzle must be kept clean to prevent wax buildup which will have an adverse effect on your listening experience. Simply clean the surface of the ear gels with an alcohol wipe and use the included cleaning tool to remove wax from the ear gels and nozzle. The most likely cause will be something related to your source device. The Klipsch products offer a far higher quality of sound Than most people expect from headphones, and you might not always realize that you are listening too loud. Refer to the "Safety" section in the front of this manual to learn more. [. . . ] The receipt must reflect that you are the original purchaser, the product was bought from an authorized Klipsch retailer, and the product is still within warranty. You will be issued a return authorization number (RA#) and asked to ship the defective product, together with proof of purchase and RA#, prepaid insured to the following address: Klipsch · This limited warranty does not cover failure of the product resulting from misuse, abuse, accident, neglect, mishandling, or wear from ordinary use or environmental deterioration. ⷠThis limited warranty does not cover consequential damage to other components including headphone cable, adaptor jack, cleaning tool, airplane adaptor, additional ear tips, large or small carrying case. No such other components of or accessories of the Product are covered by this limited warranty. [. . . ]