User manual KLIPSCH KHC-6

[. . . ] USE only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. UNPLUG this apparatus during lightning storms or when unused for long periods of time. REFER all servicing to qualified service personnel. [. . . ] Cutout dimensions are provided in the "Specification" section at the back of this manual. If accuracy of cut (straightness/squareness) cannot be achieved, you may add 1/4" to each dimension. Be careful not to cut through any existing wiring or plumbing. Avoid compromising any fire stops between studs. Included in Rough-in Kit Carton ARCHITECTURAL SPEAKERS 2. Be sure to comply with any codes that may apply in your area. (a) If you want to paint the decorative frame and the wall together, insert the frame and attach with the dogs. (b) If you will not be re-painting, you may immediately install the frame and speaker assembly. The frame's mounting dogs will "sandwich" the wall and frame together. The module is installed with the screws and the grille is pressed into place. 1. Cut the appropriate diameter circle using the hole template provided. Cutout dimensions are provided in the "Specification" section at the back of this manual. If accuracy of cut (a perfect circle) cannot be achieved, you may add up to 1/4" to the radius. Be careful not to cut through any existing wiring or plumbing. Avoid compromising any fire stops between studs. Be sure to comply with any codes that may apply in your area. (a) If you want to paint the decorative frame and the ceiling together, insert the speaker assembly and attach with the dogs. Install the paint mask in place of the grille and paint. (b) If you won't be re-painting, you may immediately install the speaker assembly. The frame's mounting dogs will "sandwich" the ceiling and frame together. The module is installed with the screws and the grille is pressed in place. K H W-5 OPERATING CONTROLS Tweeter Switch If installing in an acoustically bright room, such as some bathrooms and kitchens, you may want to adjust the tweeter level located on the front baffle. The position of this switch should always be checked prior to speaker module installation. Infrared Sensor Mount The KHW-5 features a 1/2" infrared sensor locator on the baffle. [. . . ] This Warranty does not cover products sold AS IS or WITH ALL FAULTS. REPAIRS OR REPLACEMENTS AS PROVIDED UNDER THIS WARRANTY ARE THE EXCLUSIVE REMEDY OF THE CONSUMER. KLIPSCH SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. EXCEPT TO THE EXTENT PROHIBITED BY LAW, THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS AND IMPLIED WARRANTIES WHATSOEVER, INCLUDING BUT NOT LIMITED TO, THE WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PRACTICAL PURPOSE. [. . . ]