User manual KLIPSCH KSP300

[. . . ] To reduce the risk of electric shock and fire, do not 13. Lightning and Periods of Non-Use ­ For added protection for this prodremove the cover or back plate of the device enclosure. There are uct during a lightning storm, or when it is left unattended and unused for no user serviceable parts inside. Refer servicing to an Aragon long periods of time, unplug it from the wall outlet and disconnect the authorized service center. [. . . ] The Up and Down buttons change the currently selected menu or option and the Left and Right buttons change the setting. Use the OK button to enter or exit a particular menu. Surround Speakers Front-Panel System Setup Although most of the instructions below are primarily for operation from the remote control, you can use the Stage Manager and the Enter button to set up the Stage One completely from the front panel. Press the Enter button to enter and exit the Setup Menu. Turn the Stage Manager knob to the left or right to make choices or adjustments in the selected menu. Press the Stage Manager knob to enter a particular menu. When applicable, each subsequent press of the Stage Manager will advance to the next channel or parameter. The Stage One gives you three choices for number of surround speakers--None, One, or Two--and two choices for type--Large or Small (THX). If you select Large, the surround speakers will receive full-range signals. Selecting Small will redirect bass in the surround channels below the crossover frequency to the subwoofer output if there is a subwoofer in the system; if there isn't a subwoofer, bass will be split between the front left and right speakers if they are configured as Large. The default THX setting for the surround speakers is 2 Small. Use the Left and Right buttons on the remote control or the Stage Manager on the front panel to select the Surround Speakers setting. A camera tripod can be helpful for this purpose. ) If you do not use an SPL meter, set the levels by ear so that the calibration signal sounds equally loud through all the speakers except the subwoofer. Because our ears are much less sensitive at low frequencies than at middle ones, setting the subwoofer to an audibly equal level on the test signal will make it too loud on program material. If you must set levels by ear, adjust the subwoofer level for a natural tonal balance on familiar music recordings that contain substantial bass. The test signal will either rotate from speaker to speaker at two-second intervals or stay locked to the selected speaker, depending on the setting of the Scroll Test Tones menu in the Advanced Menus. (See "Advanced Menus. ") The test signal and level-setting options will be available only for speakers selected as present in the Speaker Configuration menu. Press the OK button on the remote control or the front-panel Stage Manager to enter the Level Settings menu. Press the Left and Right buttons on the remote or turn the front-panel Stage Manager knob to adjust the level of the surround right speaker (if present) to 75dB. Press the Up button on the remote or the Stage Manager to proceed to surround back right channel level setting. Surround Back Right Press the Left and Right buttons on the remote or turn the front-panel Stage Manager knob to adjust the level of the surround back right speaker (if present) to 75dB. Press the Up button on the remote or the Stage Manager to proceed to surround back left channel level setting. Surround Back Left Front Left Press the Left and Right buttons on the remote or turn the front-panel Stage Manager knob to adjust the level of the surround back left speaker (if present) to 75dB. Press the Up button on the remote or the Stage Manager to proceed to surround left channel level setting. Surround Left Press the Left and Right buttons on the remote or turn the front-panel Stage Manager knob to adjust the level of the front left speaker to 75dB on the SPL meter. Press the Up button on the remote or the front-panel Stage Manager to proceed to center channel level setting. Center Press the Left and Right buttons on the remote or turn the front-panel Stage Manager knob to adjust the level of the surround left speaker (if present) to 75dB. Press the Up button on the remote or the Stage Manager to proceed to subwoofer level setting. Subwoofer Press the Left and Right buttons on the remote or turn the Stage Manager knob to adjust the level of the center speaker (if present) to 75dB. [. . . ] If there is any question about the operation, you should have your dealer perform it. Incorrect update procedure can render the processor inoperative. 28 WARRANTY U. S. and Canada The Warranty below is valid only for sales to consumers in the United States or Canada. The manufacturer warrants this ARAGON product to be free from defects in materials and workmanship (subject to the terms set forth below) for a period of two (2) years from the date of purchase. [. . . ]