User manual KLIPSCH PROMEDIA 2.1

[. . . ] USE only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. UNPLUG this apparatus during lightning storms or when unused for long periods of time. REFER all servicing to qualified service personnel. [. . . ] Since the ProMedia 2. 1 has its own internal amplifier, it was designed to hook into the line out connector. Connection to the speaker level output jack might result in poor sound quality. WARNING: This product is intended to be operated ONLY from the AC Voltages listed on the back panel or included power supply of the product. Operation from voltages other than those indicated may cause irreversible damage to the product and void the product's warranty. The use of AC Plug Adapters is cautioned because it can allow the product to be plugged into voltages in which the product was not designed to operate. If the product is equipped with a detachable power cord, use only the type provided with your product or by your local distributor and/or retailer. If you are unsure of the correct operational voltage, please contact your local distributor and/or retailer. CAUTION: Place the equipment near a main power supply outlet and make sure that you can easily access the power breaker switch. 230 V SOFTWARE AND HARDWARE GAIN CONTROLS Software Volume Controls in Microsoft Windows 1. Click the Start button on your taskbar 2. Windows 95: Choose Multimedia Windows 98/2000: Choose Entertainment Windows XP: Choose Entertainment 4. Adjust the Wave Volume Elevator Button to 70% Volume Control Programs Some soundcard and/or PC manufacturers may have software that must be adjusted separately from the Windows volume control. Consult applicable manual for specific hardware documentation. Subwoofer Level For CD or DVD output, the optimum position will be indicated by the mark at 10 o'clock on the sub level control. Optimum sub levels and user preference may vary from game to game. Usually a high bass level is preferred, especially at low listening levels. Remember to reset the control settings before playing CDs or films on DVD. TROUBLESHOOTING If no sound, ensure that: - Power, input, speaker cables and connectors are securely attached - Software is properly installed and functioning - Computer sound (control panel) volume is turned up and not muted - LED glowing If one or more speakers have little or no sound, ensure that: - All cables are connected properly - Connectors are fully "seated" in soundcard and speakers - Main and subwoofer level controls are properly adjusted on control pod - Computer software audio settings are adjusted for proper use - Computer system's sound (control panel) volume is turned up If the satellites or subwoofer exhibit distortion or buzzing: - Turn down computer's overall volume (via control panel), and reduce control pod volume - Turn down subwoofer's volume, as program signal may be too strong - Plug the subwoofer's power cord into a surge protector If there is noise or hissing and the volume is low even when the main volume is turned up: - Turn up computer's sound volume (via control panel) - Turn down main volume on control pod to compensate - Ensure that software/hardware is properly installed and operating If there is computer monitor interference: - Make sure the subwoofer is positioned at least 3 feet (1m) from the computer monitor - Increase the distance between the satellite speakers and the computer monitor For more detailed information and FAQs, please visit www. klipsch. com. FCC and Canada EMC Statements Approved under the verification provision of FCC Part 15 as a Class B Digital Device. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Klipsch assumes no responsibility or liability for such modification. To obtain a repair or replacement under the terms of this warranty, please contact our customer service group at 1800-KLIPSCH. You will be required to submit a copy of the original receipt via fax or email. SOME STATES, JURISDICTIONS OR COUNTRIES DO NOT ALLOW THE EXCLUSION OF CERTAIN IMPLIED WARRANTIES OR CONDITIONS, OR LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY OR CONDITIONS LASTS, SO THIS LIMITATION MAY NOT APPLY TO YOU. [. . . ]