User manual KLIPSCH PROMEDIA 2.1 WIRELESS

[. . . ] ProMedia 2. 1 Wireless Owner's Manual IMPOrtant Safety InfOrMatIOn 1. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. DO NOT defeat the safety purpose of the polarized or grounding type plug. [. . . ] NOTE: Does not work with the USB output on gaming systems. The first time the USB transmitter is plugged in, the computer should recognize the new hardware and install the appropriate driver. When plugged in, the LED on USB transmitter should begin to flash. After several seconds the LEDs on both the subwoofer rear panel and USB transmitter should stop flashing a. The LEDs should remain on ­ this indicates that the USB transmitter and subwoofer are now synchronized and audio from the computer is streaming to the ProMedia 2. 1 Wireless system. The USB wireless transmitter and subwoofer are paired at the factory, however if after 30 seconds the LEDs are still flashing, press the "SYNC" button on the rear of the subwoofer and the button (with the chevron) on the USB transmitter. If you are running Windows, open Control Panel, Sounds and Audio Devices, Audio tab, and check to make sure that "Klipsch ProMedia 2. 1 Wireless" is listed as the default audio playback device. If you are running a Mac OS, click the Apple icon, select System Preferences, Sound, Output tab, and check to make sure the "Klipsch ProMedia 2. 1 Wireless" is selected as the default output device. Start the Music Player/DVD Player software (i. e. iTunes, Windows Media Player, etc. ) and play your music as normal. NOTE: When removing the USB transmitter the computer should revert back to the computer's built-in sound output device (the laptop's built-in speaker or headphone output, for example). It may be necessary to close and restart the music player software for the change to take effect. Likewise when plugging in the USB transmitter, the Klipsch ProMedia 2. 1 Wireless speakers should become the default output device, but the music player software may need to be restarted. This is not a problem with the Klipsch system; it is a limitation of the computer's software and operating system. If after restarting the music player/DVD player software the music does not play through the ProMedia 2. 1 Wireless system, check to make sure the LED indicators are on but not blinking, and that the operating system, as described above in #4 and #5 has the Klipsch speakers selected as the active audio output device. Also check that the computer's volume control is not muted. may desire to set the volume setting higher on the Control Pod and use the computer's volume control to adjust the sound level. An initial setting of the main volume of 11 to 12 o'clock is recommended. Adjustments may be needed for best sound quality. Volume Control Programs Some soundcard and/or PC manufacturers may have software that must be adjusted separately from the Windows volume control. Consult applicable manual for specific hardware documentation. Subwoofer Level For CD or DVD output, the optimum position will be indicated by the mark at 10 o'clock on the sub level control. Optimum sub levels and user preference may vary from source to source. cOntrOL POD featUreS Headphones: The 1/8" stereo headphone output jack, located on the right-hand side of the control pod, turns off the two satellite speakers and the subwoofer output. [. . . ] 2) Make sure volume level setting on computer & control pod is correct. 3) Make sure green LED on USB transmitter and Red LED on subwoofer are not blinking. 5) Make sure "Klipsch ProMedia 2. 1 Wireless" is selected as the audio playback device. If not select it, hit apply/save and restart your music player software. [. . . ]