User manual KLIPSCH PROMEDIA GMX D-5.1

[. . . ] IMPORTANT SAFETY INSTRUCTIONS! CAUTION: RISK OF ELECTRIC SHOCK!To reduce the risk of electric shock and fire, do not remove the cover or back plate of the device enclosure. There are no user serviceable parts inside. Refer servicing to a Klipsch authorized service center. [. . . ] Plug the subwoofer's power cord into a wall outlet or AC power strip. Your GMX D-5. 1 is now ready to rumble. The Control Module Everything you need to run the GMX D-5. 1 is on the face of the control module. The function and operation of each control is listed below (see Fig. Indicates master volume setting and level trim during setup. Press the (+) and (-) buttons to raise or lower the volume. These buttons are also used to adjust the levels of the speakers in the system relative to one another (channel balance). Pressing this button selects one of the inputs. Choosing an input will cause its indicator LED above the button to light up. Pressing this button selects one of the available audio modes. Modes that can be used will depend on the input and type of signal. · Dolby Digital Signals: If you have selected one of the digital inputs, it will automatically switch to the appropriate Dolby Digital mode when a Dolby Digital signal is present. The Dolby Digital indicator LED (above the Surround button) will light. Dolby Digital modes are available only when a Dolby Digital signal is present at the selected digital input; no surround changes may be made to a discrete Dolby Digital 5. 1 signal. The Surround button will be active in Dolby Digital mode only when the signal is two-channel stereo, as described immediately below. · Stereo Signals: If you have selected the analog input or a digital input receiving a PCM signal, such as from a CD, you have a choice of four modes: Stereo, 5-Channel Stereo, Dolby Pro Logic II Cinema and Music. The Dolby Pro Logic II modes can also be applied to a Stereo Dolby Digital signal. Switch modes by pressing the Surround button until you reach the one you want, as indicated by the LEDs above the button. Stereo is indicated when no LEDs are lit. This button turns the channel test signal on and off. When on, the LED above the button will light and you will hear noise for several seconds from each satellite speaker in turn. The signal will rotate from speaker to speaker in this fashion until you turn it off. This signal has two uses: · Making sure that all speakers are connected and working. · Helping you set channel balance. [. . . ] This warranty is invalid if the factory applied serial number or date stamp has been altered or removed from this product. This Warranty is only valid for the origi nal purchaser and will automatically ter minate prior to expiration if this product is sold or otherwise trans ferred to another party . REPAIRS OR REPLACEMENTS AS PROVIDED UNDER THIS WARRANTY ARE THE EXCLUSIVE REMEDY OF THE CONSUMER. KLIPSCH SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. [. . . ]