User manual KLIPSCH REF SATELLITE

[. . . ] Figure 1 This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit. This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit. WARNING: To reduce the risk of fire or electrical shock, do not expose this apparatus to rain or moisture. Center-Channel Speaker: Center the speaker directly above or below your video screen. [. . . ] Loosen the nuts on a pair of binding posts until the holes through the metal posts are exposed, then insert the bare wire through the holes. Screw the nuts down finger-tight on the wire. Make sure that no strands of wire are touching from one binding post to the other or to any strands from the other conductor. Failure to observe this precaution at either end of the connection can result in amplifier malfunction or damag e . Pins -- Many pre-made speaker cables are terminated with metal pins. Loosen the nuts on a pair of binding posts until the holes through the metal posts are exposed, then insert the pins through the holes. Screw the nuts down finger-tight on the pins -- do not overtighten. Make sure that there is no metal-to-metal contact between the two pins or binding posts. Failure to observe this precaution at either end of the connection can result in amplifier malfunction or damage. Spade lugs -- Some speaker cables are terminated with U-shaped connectors called spade lugs. Loosen the nuts on a pair of binding posts and slip the spade lugs around the metal posts. Screw the nuts down finger-tight on the lugs and inspect to ensure they have remained firmly in place. Make sure that there is no metal-to-metal contact between the two lugs or binding posts. Failure to observe this precaution at either end of the connection can result in amplifier malfunction or damage. SPEAKERS TO AMPLIFIER: KEEPING IT STRAIGHT One of the most important things about hooking up your speakers is keeping them in the same polarity, or phase. If they are connected out of phase, bass and sound localization will be degraded. The easiest way to ensure that your speakers are wired in phase is to always connect the positive and negative output terminals on your amplifier or receiver to the matching input terminals on your speakers: positive ("+", color-coded red) to positive and negative ("­", colorcoded black) to negative. Figure 2 Also on the underside of the base are three keyholes that enables the stand to function as a wall mount. to install , follow the instructions below: 1. L o c ate the included wall mount template and bubble level and position on the wall in the desired location. Mark the screw locations for the model you are installing. Screw #8 pan head wood screws (at least two inches) long into a wood stud or dry wall anchors with the ap p r o p r i ate load rat i n g . [. . . ] Product Purchase Model and serial number must be included to honor your warranty card. What store did you purchase your Klipsch products from? k Audio/Home Theater Magazine K Other Magazine K TV K Radio K Newspaper K Trade Show K Friend K Retail Dealer K Direct Mail Have you purchased Klipsch products before?When do you hope to purchase additional loudspeakers? [. . . ]