User manual KODAK ADVANTIX 5800MRX ZOOM

[. . . ] Kodak 5800MRX Zoom Camera 1 Camera Identification 2 1 3 4 5 6 7 12 11 2 10 9 8 Camera Identification 13 14 15 16 17 P EXEFT L OP E EN D A TE S E LE C T E N TE R TI TL 18 19 20 21 23 26 25 24 3 22 LCD Panel 27 28 29 30 0-00-00 OFF FILL 200 ISO 36 35 34 33 32 31 4 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: Your model camera has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits provide reasonable protection against interference in residential use. [. . . ] Press the SELECT BUTTON (23) repeatedly until "INFINITY" appears on the TEXTMESSAGING PANEL (30). Frame your subject within the VIEWFINDER EYEPIECE (14). Partially depress the SHUTTER BUTTON (1), and when the FLASH/CAMERA-READY LAMP (13) glows green, fully depress the shutter button to take the picture. Using the Self-timer You can include yourself in pictures by using the self-timer feature. The electronic self-timer will delay the release of the shutter button for approximately 10 seconds after you press the shutter button. Place the camera on a tripod (TRIPOD SOCKET [24]) or on another firm support, and press the ENTER BUTTON (22). Wait for the TEXT-MESSAGING PANEL (30) to display "SELFTIMER READY. " 2. Frame your picture in the VIEWFINDER EYEPIECE (14). The SELFTIMER LAMP (7) on the front of the camera will blink during the self-timer countdown. · To cancel the self-timer selection before the shutter releases, press the enter button or close the flash. · The self-timer automatically turns off after the shutter releases. 19 Using the Remote Control The IR Remote Control RC-3 allows remote camera operation up to 20 ft (6. 1 m) away. Place the camera on a tripod (TRIPOD SOCKET [24]) or on another firm support. Press the ENTER BUTTON (22) repeatedly until "REMOTE READY" appears on the TEXT-MESSAGING PANEL (30). Arrange the camera and subject positions and compose your picture. Point the REMOTE (8) toward the front of the camera and press the remote button. The REMOTE-CONTROL LAMP (7) blinks and the shutter releases after approximately 3 seconds. · After you take the picture, the remote control is canceled. Changing the remote-control battery The remote control uses a 3-volt lithium KODAK KCR2032 (or equivalent) Battery. Replace the battery when the remotecontrol button does not release the shutter. Remove the three screws on the back of the remotecontrol cover. Replace cover and re-attach the screws. 20 Date and Time Imprinting This camera has a quartz clock and automatic calendar through the year 2099. You can record the date in a choice of three formats: (year/month/day, day/month/year, month/day/year) or time (hour/minute). Traditional cameras print date and/or time information directly onto the film. Your camera uses the film's magnetic data-recording capability to record date and time information which your photofinisher imprints on the back of your photographs. Setting the date and time 1. [. . . ] Turn the camera upside down and slide the FILM-DOOR LATCH (17) to open the FILM DOOR (18) and to partway eject the film. 2 1 4 3 3. Remove the film cassette from the camera and reload with new KODAK ADVANTIX Film. · The FSI on the fully-exposed film cassette will be at " (#3 position). Mid-roll change (MRC) This camera has MRC feature where a partially exposed film cassette can be rewound for later use. The FSI on a partially exposed film cassette will be set to (#2 position). [. . . ]