User manual KODAK CAROUSEL NEW LOOK PROJECTOR

[. . . ] {ServiceManual}{Production}{KodakServiceSupport} Publication No. SM5440-1 18NOV97 Supersedes SM5440-1 13MAY97 Kodak Home Page on Internet SERVICE MANUAL for the Kodak Carousel NEW LOOK PROJECTORS Standard and Long Life Models 4200, 4200-J, 4200-KK, 4400, 4600, 4600-KK, 5600, 5600-J, and 5600-KK Intranet Table of Contents © Eastman Kodak Company, 1999 A100_0029HA PLEASE NOTE The information contained herein is based on the experience and knowledge relating to the subject matter gained by Eastman Kodak Company prior to publication. No patent license is granted by this information. Eastman Kodak Company reserves the right to change this information without notice, and makes no warranty, express or implied, with respect to this information. [. . . ] [2] Do the removal for the MECHANISM ASSEMBLY. [3] Place the MECHANISM ASSEMBLY on the MECHANISM RUNNING FIXTURE. [4] Check the alignment of the INDEXER LEVER with the hole in the TOP PLATE ASSEMBLY at Position 1. [5] Bend the INDEXER LEVER to the correct position. [6] Check the travel of the INDEXER LEVER in the FORWARD position. When the INDEXER LEVER moves in the FORWARD position, the gate edge of the black plastic should be between the 2 holes at Position 2. [7] Bend the INDEXER LEVER until you reach the correct position. MECHANISM ASSEMBLY TOP PLATE Bend here. MECHANISM RUNNING FIXTURE position 1 position 2 A091_0008HCA A091_0008HA Adjustment Specification Use a MECHANISM RUNNING FIXTURE. Use TL-3001 to measure the height of the SLIDE LIFT LEVER. The LEVER should make contact with the low surface of TL-3001. The LEVER should not make contact with the high surface of TL-3001. 26 18NOV97 ­ SM5440-1 Adjustments Adjusting the SLIDE LIFT LEVER MANUAL, with MECHANISM Out Warning Dangerous Voltage [1] Disconnect the main power. [2] Do the removal for the MECHANISM ASSEMBLY. [3] Place the MECHANISM ASSEMBLY on the MECHANISM RUNNING FIXTURE. [4] Press and hold the SELECT LEVER down to move the SLIDE LIFT LEVER to the highest position. [5] Measure the height of the SLIDE LIFT LEVER. The SLIDE LIFT LEVER should make contact with the low surface of the SLIDE LIFT LEVER GAUGE TL-3001; the SLIDE LIFT LEVER should not make contact with the high surface of the SLIDE LIFT LEVER GAUGE TL-3001. [6] Bend the SLIDE LIFT LEVER until the adjustment is correct. SLIDE LIFT LEVER GUAGE TL-3001 SLIDE LIFT LEVER SELECT LEVER (not shown) A091_0016BCA A091_0016BA Adjustment Specification Use MECHANISM RUNNING FIXTURE. Use TL-3001 to measure the height of the SLIDE LIFT LEVER. The LEVER should make contact with the low surface of TL-3001. The LEVER should not make contact with the high surface of TL-3001. Adjusting the SLIDE LIFT LEVER POWER with Mechanism Out Warning Dangerous Voltage [1] Disconnect the main power. [2] Do the removal for the MECHANISM ASSEMBLY. [3] Place the MECHANISM ASSEMBLY on the MECHANISM RUNNING FIXTURE TL-3000. [5] Press and hold the SELECT LEVER down to move the SLIDE LIFT LEVER to the highest position. [. . . ] Check that the MAIN PROJECTION LAMP operates correctly. Insert the TARGET SLIDE TL-3002 in the GATE MECHANISM. · Check that the TARGET is correctly aligned. Check that the voltages across the PHOTOCELL are correct. [. . . ]