User manual KODAK ESP3 ALL-IN-ONE PRINTER

[. . . ] All-in-One Printer User's Guide Eastman Kodak Company Rochester, New York 14650 © Eastman Kodak Company Kodak and EasyShare are trademarks of Eastman Kodak Company. The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. , and any use of such marks is under license. (Image Recognition Integrated Systems), All Rights Reserved P/N IK3254 Revision C May 2008 Table of Contents 1 Product Overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Memory Card Slots . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Memory Cards Supported. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] These indicators blink very slowly when ink levels are low, and fast when the ink cartridge should be replaced or need attention. Replacing Ink Cartridges Important For the best quality prints, store ink cartridges in a location where the temperature does not exceed 85°F (30°C). Warning Use genuine Kodak ink cartridges to ensure best results and avoid printhead damage not covered under warranty. Third-party ink cartridges may not contain the necessary Smart Chip information to notify you before the ink cartridge is empty. 1 Make sure the printer is on. 2 Open the printer access door by lifting from the front center of the unit. The printhead moves to a center position. The ink tanks are located in the printhead. 1 Printhead 2 Color ink cartridge 3 Black ink cartridge 3 Wait until the printhead is idle and silent, then pinch the latch on the old ink cartridge with your thumb and forefinger and lift it out of the printhead. Note You can take your used ink cartridges to most office supply or electronics stores for safe disposal. 4 Open the box containing the new ink cartridge. Chapter 7 5 Remove the bagged ink cartridge from the box, tear open the bag at the notch, and remove the ink cartridge. Important Insert the ink cartridge immediately to prevent any drying of the ink. 6 Remove the orange cap from the cartridge by grasping the top edge and pulling/rotating it off the ink cartridge. Discard the orange cap. 7 Insert the ink cartridge into the printhead. 8 Press down on the tab until you hear a click and feel the latch snap into position. 9 Close the printer access door. The printhead moves to its ready position. Printhead The printhead dispenses the ink from the ink cartridges onto the paper. 36 Kodak ESP 3 All-in-One Maintenance Printhead Alignment The printhead may need to be aligned to enable high-quality prints. The Kodak printer automatically performs a calibration every time you install or replace a printhead. You can also initiate a printhead alignment from the ESP 3 printer driver, Home Center software, or control panel. To align the printhead from the control panel 1 Load the paper tray with US letter or A4 Kodak plain paper. 2 On the control panel, press and hold Scan and Cancel at the same time until the On/Off light starts blinking. The following pattern is printed and calibration is complete when the page is printed. Clean Printhead Run a printhead cleaning if color is faded or missing by pressing and holding Copy and Cancel at the same time. Chapter 7 Replace the Printhead If your printhead is damaged or broken it is easy to replace yourself. 1 Make sure the Kodak ESP 3 All-in-One printer is on. 2 Open the printer access door. 3 Pinch the latch on the ink cartridge with your thumb and forefinger and lift it out of the print head. Remove both ink cartridges. 4 Unlatch the printhead by pressing by pressing the release button on the top center of the carriage. 5 Remove the old printhead from the carriage. 38 Kodak ESP 3 All-in-One Maintenance 6 Remove the new printhead from its bag. 7 Remove and discard the black plastic casing and the orange protective cap. 8 Place the new printhead into the carriage. 9 Push firmly against the target label on the printhead until it clicks into place. 10 Reinstall the ink cartridges. A calibration page automatically prints. 8 Support Support Contact Kodak Kodak provides several resources to help you solve problems with your Kodak printer. · Troubleshooting information (see Troubleshooting). · Additional technical information (in the ReadMe file located on the Kodak EasyShare software CD). · Support from the Kodak Web site (www. kodak. com/go/support). · Update the Kodak Home Center software (www. kodak. com/go/downloads). · Update the printer and scanner driver software (www. kodak. com/go/downloads). [. . . ] When not enough time elapses between the flash and exposure (as with most compact cameras), the light of the flash occurs too fast for the iris of the eye to close the pupil. The flash of light is focused by the lens of the eye onto the blood-rich retina at the back of the eye. The image of the illuminated retina is then focused by the lens of the eye back to the camera, resulting in a red appearance of the eye on the picture. 64 Kodak ESP 3 All-in-One Glossary Index B borderless. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 52 loading paper. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 M maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]