User manual KODAK DCS PRO SLR/N DIGITAL CAMERA POCKETWIZARD USER'S GUIDE

[. . . ] 1-7 Setting the Transmit Zone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-7 Setting the Receive Zone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-7 Test Flash . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-8 Test Radio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] NOTE: Devices on the same channel work together. Channels 17 - 32 let you set zones (see page 1-7) and receive flash / triggering confirmation (see page 1-8). NOTE: Flashes with POCKETWIZARD Inside do not have a user interface. You have to set their channels using the Teach Channel function (see page 1-12). Choose Transmit or Receive, then choose Channel. 2. Press the right side of the Four-way switch to display two boxes where you can select the channel. Press the right or left side of the Four-way switch to highlight the ten's or the one's position. Press the top or bottom of the Four-way switch to increase or decrease the value. Press the OK button. 1-6 July 12, 2004 Using your Camera with a POCKETWIZARD Radio Transceiver Setting the Zone If you have selected a channel between 17 - 32, you can assign different zones to remote devices, then turn the zones on or off. For example, if you have several flashes in your studio setup you can assign different zones to flashes, then turn some zones on and some off. This way you can decide which flashes will be used without making manual adjustments. Setting the Transmit Zone When your camera is in Transmit mode, you can specify the zones you will transmit to. Choose Transmit, then choose Zone A, B, C, or D. Repeat for all four zones. Setting the Receive Zone When your camera is in Receive mode, enter the zone as determined by the setup. NOTE: If you are on channels 1 - 16, you will not select a zone. If you are on channels 17 - 32, you may select a single zone in Receive mode. Choose Receive, choose Zone, then choose A, B, C, or D. Press the OK button. July 12, 2004 1-7 Using your Camera with a POCKETWIZARD Radio Transceiver Test Flash You can perform a test flash to determine that your setup is correct. If the Strobe Confirm feature is turned on (see page 1-10), flash status (indicated by the lightening bolt symbol) appears on the Test Flash screen. If Strobe Confirm is turned off, only radio status appears. Choose Test Flash from the POCKETWIZARD menu. Any remote devices set in Receive mode perform a test flash. A screen displays the results of the test flash. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. [. . . ]