User manual KODAK RP 50

[. . . ] KODAK PROFESSIONAL RP 50 LED Printer Operator's Guide Part No. 2J0686 ©Eastman Kodak Company, 2002 All rights reserved. Contents of this publication may not be reproduced in any form without permission from Eastman Kodak Company. Regulatory Information Radio Frequency Interference The United States (47 CFR Part 15 Subpart B, FCC Class A, EMC) This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] · The printer was reinitialized while paper was being fed into the processor. Possible Solution Reinitialize the printer. Wait for initialization to complete and try the function again. Wait for the previous function to complete and try the function again. Load a full paper cassette into the printer. Remove the tail end of the paper at the supply door and load a full supply cassette into the printer. · Check that the processor fully takes a sheet of paper and reinitialize the printer. · Check for a paper jam in the sheet transport area. CAUTION: Always pull the sheet of paper out from the processor to avoid bringing chemicals into the printer. · If problem continues, call for service. Wait for the motor move to complete or stop the motor and reissue the command. Wait for the motor move to complete or stop the motor and reissue the command. Reinitialize the printer. 4 out of paper 5 end of roll at supply 6 7 8 9 11 paper already loaded supply door open, please close front door open, please close back door open, please close sheet detected in sheet xport 12 motor busy A low level motor move command was issued while the timer motor was in use. A low level motor move command was issued while the timer motor was in use. The printer cannot execute the requested command. 13 motor setup invalid 14 bad printer state 5-4 October 2002 Diagnostics and Troubleshooting Error Code 15 Error Message timers busy Possible Cause A low level motor move command was issued while the timer motor was in use. A spurious (false) timer interrupt has occurred. The function requested is not supported in this software release. The 300 board sent an unexpected message to the 200 board. The service switch for the 200 board is on, enabling on-board LEDs that can cause fogging. The service switch for the 300 board is on, enabling on-board LEDs that can cause fogging. The paper cassette is empty and tail of the paper has been fed into the sheet transport area. Attempting to perform a function while paper is being loaded. Attempting to perform a function while the printer detects a problem with the processor. [. . . ] Change the color mode using the PHOTOSHOP Mode menu. The file is too large for the paper installed!Resize the image in PHOTOSHOP before printing. Change the size of the image using the PHOTOSHOP Mode menu. [. . . ]