User manual KOHLER SV540

[. . . ] OWNER'S MANUAL COURAGE SV470-SV620 VERTICAL CRANKSHAFT Safety Precautions To ensure safe operation please read the following statements and understand their meaning. Also refer to your equipment owner's manual for other important safety information. This manual contains safety precautions which are explained below. WARNING Warning is used to indicate the presence of a hazard that can cause severe personal injury, death, or substantial property damage if the warning is ignored. [. . . ] NOTE: To prevent extensive engine wear or damage, always maintain the proper oil level in the crankcase. Never operate the engine with the oil level below the "L" mark or over the "F" mark on the dipstick. Figure 7. If the level is low, add oil of the proper type, up to the "F" mark on the dipstick. (Refer to Oil Type on page 4. ) Always check the level with the dipstick before adding more oil. NOTE: To prevent extensive engine wear or damage, always maintain the proper oil level in the crankcase. Never operate the engine with the oil level below the "L" mark or over the "F" mark on the dipstick. Oil SentryTM Some engines are equipped with an optional Oil SentryTM oil pressure switch. If the oil pressure decreases below an acceptable level, the Oil SentryTM will either activate a warning signal or shut off the engine, depending on the application. NOTE: Make sure the oil level is checked BEFORE EACH USE and is maintained up to the "F" mark on the dipstick. This includes engines equipped with Oil SentryTM. Change Oil and Filter Change the oil and oil filter annually or every 100 hours of operation. Refill with service class SG, SH, SJ or higher oil as specified in the Viscosity Grades table (Figure 2) on page 4. Change the oil and filter while the engine is still warm. The oil will flow more freely and carry away more impurities. Make sure the engine is level when filling, checking, or changing the oil. Use chart below to determine part number to order. 12 050 01-S 52 050 02-S Length 2-1/2" 3-3/8" Oil Drain Plug Oil SentryTM (Behind Blower Housing) Change the oil and oil filter as follows (see Figure 8): 1. To keep dirt, grass clippings, etc. , out of the engine, clean the area around the oil fill cap/ dipstick before removing it. Oil Filter Figure 8. Oil Drain Plug, Oil Filter, and Optional Oil SentryTM Switch. 9 Service Precleaner and Air Cleaner Element This engine is equipped with a replaceable, high density paper air cleaner element. Some engines are also equipped with an oiled, foam precleaner, located in the outer air cleaner cover. Check the air cleaner daily or before starting the engine. Check for a buildup of dirt and debris around the air cleaner system. Also check for loose or damaged components. [. . . ] service center as soon as a problem exists. Call 1-800-544-2444 or access our web site at: www. kohlerengines. com, for the names of the nearest service centers. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. (c) If you have any questions regarding warranty rights and responsibilities, you should contact Kohler Co. at 1-920-457-4441 and ask for an Engine Service representative. [. . . ]