User manual KOMPERNASS BALANCE KH 805 DESIGN BATHROOM GLASS SCALE

[. . . ] Furthermore it protects inner organs and regulates body temperature. Body fat rate varies depending on age and sex. Following table shows how much body fat is regarded as healthy: Body Fat Rate (%) Age 20-24 25-29 30-34 35-39 40-44 45-49 50-59 >60 Low 18-22 19-22 20-23 21-24 23-26 24-27 27-30 28-31 Women Normal 22-25 22-26 23-27 24-28 26-30 27-31 30-33 31-34 High 25-30 26-30 27-31 28-31 30-33 31-35 33-36 34-38 Low 11-15 12-17 14-18 16-20 17-21 18-22 20-23 20-23 Men Normal 15-19 17-21 18-22 20-23 21-24 22-25 23-26 23-26 High 19-24 21-25 22-25 23-26 24-27 25-28 26-29 26-30 4 Depending on the age, human body exists till 80% of water (see table below). [. . . ] Water serves important metabolism functions: it regulates body temperature and transports nutrients between cells and organs. Since body loses water all the time, water must be replaced to save from water deficiency, which causes a concentration of toxins in body. It can even be life-threatening if human body loses more than 20% of its average water content. Water content Baby 1st day Baby 3rd month Adult 25 years Adult 85 years 80% 70% 60% 50% Bioelectric Impedance Analysis (BIA) Our handy Body Fat and Water Level Analyzer is working with the BIA technology. This means that a low, non-noticeable and absolute innocuous voltage is conducted through the body. Then the impedance (resistance) the voltage meets on its way through the body is being measured. The more muscles the body has, the more water it contents and the voltage can easily pass the body. The more fat the body has, the bigger the resistance is that the voltage meets on its way through the body. Setting user's basic information: Select user (USER 0 to 10) and then press SET for 2 seconds to enter into setting mode for weight / key to change setting. (Fig1), height (Fig2), sex (Fig3) and age (Fig4) that go flashing. Use the After each setting, press SET to enter into the following, until successful setting (USER1 to10 will memorize all basic information as set). 8 Body fat measurement: Select user USER0 to 10 and then press SET (for less than 1 second) and you are in Standby Mode (Fig5). By following the instructions given in Fig. 6 and Fig. 7, measurement starts when you have both hands touch the electric panel. The result will be displayed in about 5 seconds. Both data will flash alternatively every 2 seconds. button to fix user (USER 1 to 10 ) then press button, If would like to recall previous data , press you may know your stored memory In the device. 11 performed by LCD display alternatively. [. . . ] 11 performed by LCD display alternatively. If all 10 memories are full, the oldest data will be replaced. (3) Alarm clock mode Start Alarm Mode: press button you may select to open or close alarm. How to set up alarm: In Time Mode press MODE twice to enter into the Alarm Mode. [. . . ]