User manual KOMPERNASS BIFINETT KH 1134 PLASTIC WATER HEATER WITH THERMOSTAT

[. . . ] Always pull the plug out of the power socket after use. Switching off the device is not sufficient because the device receives power as long as the power plug is connected to the socket. · · 2. Technical Data Voltage : 220 - 240 V ~ / 50 Hz Power consumption :2500 - 3000 W In older electrical installations, the building fuse (12A) may be triggered due to the high power consumption. · · 3 Operating elements Lid Unlocking button ON/OFF switch Operating light Base Temperature control Kettle Level indicator Spout screen To prevent the risk of fire or injury: · Always heat water with a closed lid , otherwise the automatic cut-out mechanism doesn't work. Boiling water can then spray out over the edge. [. . . ] · Set the desired water temperature using the temperature control . To bring the water to a boil, you must set the temperature controller to the MAX position. · Now insert the power plug into the power socket . . . · and press the ON/OFF switch down until it snaps in. · The operating light indicates that the device is now heating up. ar w mr ange Transitionrange kee p ng boili ra nge MIN MAX -4- KH1134_Wasserkocher_IB_UK_neu 16. 10. 2006 13:45 Uhr Seite 5 bifinett KH 1134 Temperature regulator in the boiling range: · The devices switches off automatically and the operating light goes out as soon as the water is at a full boil. In order to keep the water warm after bringing it to a boil, set the temperature regulator in the keep warm range. Press the ON/OFF switch down, until it snaps in. Temperature regulator in the keep warm range: The left end of the keep warm range indicates the lower temperature. The right end of the keep warm range indicates the higher temperature. (The water does not start boiling in the keep warm range!). · After reaching the desired temperature, the appliance switches off the heating process. The ON/OFF switch and the operating lights remain switched on. Because the device is equipped with a heat maintenance function, the device automatically begins reheating as soon as the water temperature falls below the set temperature. The appliance heats until the desired temperature is reached. Make sure that the appliance does not automatically switch on to the keep warm function. Therefore, do not leave the appliance unsupervised!· As soon as the kettle is lifted from the base , the ON/OFF switch jumps out and the operating lights switch off. · In order to halt the heating process, push the ON/OFF switch up again. The operating light goes out then as well. Avoid setting the temperature regulator in the transition range, as the water can start boiling on account of varying filling levels. Warning!: Pull the power plug from the socket before lifting the kettle from the base . This prevents any water splashing out from contacting the electrical connections in the base, which could cause a short circuit. For safety reasons, the lid should not be opened while the water is boiling or is very hot. [. . . ] Storage Let the device cool completely before storing it. · Wind the power cord around the holder on the bottom of the device. · Store the device in a dry place. 9. Disposal Do not dispose of the device in normal domestic waste. [. . . ]