User manual KOMPERNASS BIFINETT KH 2210 WATER KETTLE WITH THERMOSTAT TUNER

[. . . ] · Make sure that the power cord never becomes wet or damp during operation. Lay the cord such that it cannot be pinched or otherwise damaged. Allow only customer service to replace damaged power cords or power plugs, before using the appliance again (see "Warranty & Service"). · Always pull the plug out of the power socket after use. [. . . ] · Do not separate the kettle º from the base station while the appliance is in operation. · An improper use or handling of the appliance may lead the appliance to malfunction and cause injuries to the user. · No liabilities shall be accepted for damages caused by improper or wrong use. Clean the kettle º, by pouring water into it and bringing it to a boil (See "Boiling water"). Pour out the water and repeat the process. Operation 1. Pull the power cord out only as much as is necessary. Pull it out by opening the base station and connect the plugs with an appropriate power socket. Open the lid and fill in with the desired quantity of water. Please note the level indicator of the appliance. - atleast up to the MIN mark, so as not to overheat the electric water kettle. ­ no higher than the MAX mark so that no boiling water spills out. Close the lid and place the appliance on the base station . The appliance can only be switched on if it is fixed to the base station. Keep the On/Off switch on , , "- position. The appliance begins to operate, the indicator lamp begins to flash. If the water is boiling the appliance switches off automatically. The On/Off switch automatically moves to the "O" position, the indicator lamp turns off. If you want to stop or interrupt the boiling process, keep the On/Off switch on the "O" position. However, you can continue the boiling process by waiting for 20 seconds until the heating element has cooled off. You can then switch on the appliance once again. -4- KH2210_IB_UK 11. 09. 2006 14:58 Uhr Seite 5 bifinett KH 2210 During the cooling phase, do not press the on/off switch , as this can damage the appliance. [. . . ] Kompernaß GmbH Burgstrasse 21 D-44867 Bochum www. kompernass. com Cleaning Please follow the safety instructions as well. Always unplug the power cord from the socket, before cleaning the base station . Allow the kettle º to cool down completely. · Clean the outer side of the kettle and the base station with a soft, damp cloth. [. . . ]