User manual KOMPERNASS BIFINETT KH 700 UNIVERSAL KOKSMASKIN

[. . . ] · Use only the supplied original accessories since these have been optimised for interaction with the device. Other parts might not be sufficiently safe either. · Never switch on the device without there being ingredients in the vessels. · The cutting edges are very sharp! [. . . ] Hints: · Cut the ingredients in approximately 3 cm large pieces before placing them in the bowl. · The device chops the ingredients very fast so that you should only run it very briefly at a time. · Do not operate the device for longer than 30 seconds. · Should ingredients be trapped in the bowl or on the cutting blade: - Switch off the device - Remove the lid from the mixing bowl - Remove the ingredients with a dough scraper / spatula. · Fit the mixing bowl. Hold the bowl by the handle and turn clockwise until it engages with a "click". · The pusher is equipped with a measuring cup. If you remove it you can reduce size of the filling shaft. This can be useful when cutting or grating relative small food. · Remove the cutting blade from the protective case. · Turn the lid clockwise until it engages with a "click". The marks on the lid and the bowl must match. The lug of the lid now rests on the handle of the bowl. · Fit the mixing bowl to the food processor. · Fit the cutting blade on the retainer and place the latter on the drive shaft. 6 7 7. 2 Working with the cutting and grating discs Caution: The cutting edges are very sharp!Be particularly careful when inserting and removing or cleaning the discs!Never use your fingers, spatula, spoon handles or similar objects for pushing foodstuff through the filling shaft! · Fit the retainer to the drive shaft. Insert thumb and index finger in the holes of the disc holder and place it on the retainer. · Place the lid on the bowl. 7. 3 Working with the kneading blade With the kneading blade you can knead bread dough and mix batter or cake mixture. · Place the mixing bowl on the food processor. · Place the kneading blade on the retainer and fit on the drive shaft. · Add the ingredients to the mixing bowl. 8 Working with the blender Caution · Never switch on the blender when empty. · Never insert the plug in the socket before the blender jug and the blender lid have been correctly assembled. · Always pull the plug from the socket before removing the blender jug. · Do not fill ingredients hotter than 80°C in the blender jug. · To avoid splashing, never add more than 1. 5l of liquid in the blender jug. · Never remove the blender lid during operation. [. . . ] To do so, simply remove the splash protection cap. · If you process hot liquids, remove the splash protection cap to allow the steam to escape. · Should ingredients be trapped in the blender jug during operation, proceed as follows: - Switch off the device (speed controller to speed 0) and pull the plug from the socket - Remove the splash protection cap and the lid - Remove the trapped ingredients in the blender jug using the dough scraper. - Ensure you do not damage the scraper with the blade! · Pull the plug from the socket before every cleaning. [. . . ]