User manual KOMPERNASS EBENCH KH 350 DESIGN AUDIO SYSTEM WITH CD PLAYER AND DIGITAL RADIO

[. . . ] When setting-up the device ensure that it is not in the immediate vicinity of heat sources, e. Ensure that the device is set-up upon a stable and level base. the device must be set-up in a place that guarantees sufficient all-round ventilation. The distance between the device's rear-side and wall should not be less than 10 cm, also not less than 10 cm above the device and at least a 5 cm space on either side. [. . . ] Mode Headphones connection Controls the volume Switches the system on/off Activates the preview function Activates the random play function Starts playing/pauses CD Selects AM/FM waveband Activates the programming function Repeats individual/all CD tracks When used with CD player: skips to the begin ning of the next track/to the beginning of the track which is currently playing or forward/ reverse search; When used with the tuner: automatic tuning Stops playing the CD Changes display: track playing time/remaining playing time of entire CD Connecting the loudspeakers To connect the loudspeakers, connect each black cable to the (--) connecting terminal and each red cable to the (+) connecting terminal at the back of the appliance. Mains operation Before you continue, check whether the mains voltage stated on the back of the appliance corresponds with your local mains voltage. Then insert the mains plug of the appliance into a socket. Note: If the equipment is not be used for a long period, take the batteries out of the remote control. After pressing the MEMO/PROGRAM button in the standby mode, press the SKIP/SEARCH but tons (forwards/backwards) until the correct hour appears on the display. Press the MEMO/PROGRAM button again and then press SKIP/SEARCH (forwards/backwards) until the correct minute appears on the display. The correct time will now appear on the display. When the CD starts, the total number of tracks will appear on the display. The display indicates the number of the current track and the playing time of the track. to activate the pause function , press the PLAY/PAUSE button. The display indicates how much of the track's playing time has lapsed. The display indicates the total number of tracks and the total CD playing time. Repeat function This function allows you to play an individual track or all the tracks on one CD repeatedly. To play an individual track repeatedly, press the MEMO-UP/REPEAT button twice while the CD is playing. To deactivate the repeat function, press the MEMO-UP/REPEAT button again until REPEAT dis appears from the display. Programmed play function With the programming function you can compile your own music programme. Before programming, the CD must be stopped by using the STOP button. Press the MEMO/PROGRAM button again in order to programme the selected track. Repeat steps 2 and 3 until all the required tracks have been programmed. Press the STOP button in order to end the programmed play function. [. . . ] The reception can be improved by turning the appliance. If you wish to connect another audio appliance (e. A cassette deck) to your design audio system in order to use the system's loudspeakers to play music, you must connect this appliance with a cinch cable to the inputs marked "AUX" on the back of your design audio system. Then press the AUX button; it is now possible to start playing music from the connected appliance via the design audio system. [. . . ]