User manual KOMPERNASS EBENCH KH 994 KITCHEN RADIO

[. . . ] The manufacturer accepts no responsibility for damage caused by misuse of the equipment or the non-observance of these safety advice notes. Do not allow the radio to come into contact with moisture. If this happens there is the danger of electric shock. Therefore you must not operate the radio with wet hands. [. . . ] 3) Mark the four positions for the holes. 5) Screw on the mounting plate (see Fig. ). 4 Power failure backup: The power failure backup batteries ensure that the time and wake-up time settings are preserved during short-term power failures. 1) Slide the battery compartment cover to the side. Always pay attention to the correct polarity. 3) Close the battery compartment cover. Fixing the radio in position: · Place the radio on to the mounting plate and slide it to the rear. Power supply: · Insert the plug into a 230 V / 50 Hz supply socket. Wire aerial: · Unwind the wire aerial fully and fix it in place using e. g. adhesive tape. SETTING THE TIME Press and hold down the time button · and press the hours button ¸ or the minutes button µ as required to set the correct time. PM is indicated by a small dot in the upper left corner of the display. RADIO Switching on the radio: Slide the On/Off switch into the RADIO ON position. A dot ¾ lights up on the display ¿ to indicate that the radio is switched on. Band selection: Use the band selector ¶ to select the band (FM = VHF, AM = MW). Station selection: Set the radio to the required station using the STATION selector ². You can read the frequency set on the scale ». It may be necessary for you to adjust the position of the aerial. When you find good reception, you can fix the aerial in place with some adhesive tape. Volume adjustment: Use the volume control º to change the volume. TIMER Your kitchen radio has an integrated timer. You can set any time you like between 1 minute and 1 hour and 59 minutes. Time is counted down and the remaining time is shown in the display ¿. Setting the time: 1) First of all make sure that the RADIO switch is set to ON or OFF (and not to AUTO !). First the display ¿ shows a standard value of 0:59 - which means a countdown period of 59 minutes. 5 3) To increase the countdown period press the hours button ¸. The display ¿ now shows 1:59 ­ this is the maximum countdown period. 4) To change the minutes setting, press the minutes button µ. As you hold down the minutes button µ, the minutes are automatically decreased. [. . . ] 4) The alarm tone will switch itself off automatically after approx. Of course, you can switch of the alarm tone before this. Further details can be found in the next section. Switching off the alarm tone: · Press the wake-up time button ³ to switch off the alarm tone. · The set wake-up time remains unaltered. [. . . ]