User manual KOMPERNASS KH 2909 COMPOUND MITRE SAW

[. . . ] Do not overburden the saw and saw blade. Use a saw blade that is appropriate for the work piece. [. . . ] This saw is not intended for commercial applications. Do not use the saw for any purpose other than the intended one. After use, clean the mitre saw with a brush and smear the saw blade with oil. Dispose of the appliance through an approved dis-posal centre or at your community waste facility. observe the currently applicable regulations. In case of doubt, please contact your waste disposal centre. Place the guide piece in the saw support and then connect it to the saw arms (Fig. Fit the saw blade and then put it under tension by tightening the wing nut on the tension bar (Figs. Firmly fit the four guide rods to the saw table with the screws and washers (Fig. Fit the spacers at the front and rear each onto one of the guide rods (Fig. Fit the carrying handle on to the top of the guide rods with the screws (Fig. To be able to use the saw without a table, the carrying handle must first be released from the guide rods (Fig. [. . . ] Then pull the latching bolts down and incline the saw until until the bolts engage in the next position. Lämna in den till ett företag som har tillstånd att ta hand om kasserade apparater av den här typen eller till rätt återvinningsstation på din kommuns avfallsanläggning. [. . . ]