User manual KOMPERNASS KH 4209 ILLUMINATED FLOWER POT

[. . . ] â· If the batteries have leaked, to avoid the risk of injury through chemical burns put on a pair of protective gloves before removing the batteries. Clean the battery compartment and the battery contacts with a dry cloth. â· Keep batteries away from children. [. . . ] â· Do not operate the appliance in close vicinity to lightly inflammable or explosive materials or objects. Connect the power cable with the power supply unit 1: Insert the plug 2 of the power cable into the socket on the power supply unit 1. Lead the power cable 5 through one of the chases 4 on the base of the flower pot, so that the flower pot itself does not stand on the power cable 5. Insert the power supply unit 1 into a correctly installed mains power socket. Connector power pack Input voltage : 230 - 240 V ~ 50Hz Output voltage: 6 V ~ 1000 mA Output level: 6 VA Protection class: IP 44 Protection class: II / Remote control 1x Button battery CR2025, 3 V (Batteries not supplied) LED Class 1 To operate the remote control you will need a button battery CR2025, 3 V. 1 Power supply unit 2 Plug 3 Coupling ring 4 Chase for the power cable 5 Power cable 6 Infra-red diode 7 Button N1 On/Slow 8 Button N2 On/Quick 9 Button N3 On/Select Colors 0 Button N1 & N2: Speed N3: Brightness q Button N1 & N2: Speed N3: Brightness w Battery compartment e Button OFF Pull the battery compartment w out of the remote control, by first pressing the lateral locking device and then drawing the battery compartment w outwards. â· Remove the depleted battery, then insert a new battery of the type CR2025 (Button battery) into the battery compartment w. Ensure that you correctly insert the battery in regard to its polarity (see illustration). You can control the various functions with the remote control . Always remove the power supply unit 1 from the mains socket before cleaning the appliance. Clean the flower pot and the remote control with a lightly moistened cloth. There should be no objects located between the remote control and the flower pot. Otherwise, the remote control will not function. To switch the remote control on, press one of the following buttons: N1 On/Slow 7 The LEDs switch themselves on and the colours flow into one another. N2 On/Quick 8 The LEDs switch themselves on and the colours change themselves abruptly. N1 & N2: SPEED N3: Brightness 0 With every activation when the functions N1 or N2 are engaged, the colours change faster. [. . . ] In case of doubt, please contact your waste disposal centre. Used batteries/rechargeable batteries may not be disposed of in household waste. Every consumer is statutorily obliged to dispose of batteries or rechargeable batteries at a collecting point in his town / district or at a shop selling batteries. [. . . ]