User manual KOMPERNASS KH 4013 DECORATIVE-NATURAL-STONE INDOOR WATER FOUNTAIN

[. . . ] Bedienungsanleitung E- D Kompernaß Handelsgesellschaft mbH Burgstraße 21 D-44867 Bochum, Deutschland www. kompernass. com -- E-2896/2 · 26. September 2003 Bedienungsanleitung | D Inhaltsverzeichnis 1. Technische Daten. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Verwendung. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Your natural-stone water fountain is ready for operation now. Switch on the natural-stone water fountain with the switch. IRL | Operating Instructions . Adjusting pumping rate and water flow Pumping rate of the water pump is infinitely variable and allows to adjust higher or lower water flow when the natural-stone water fountain is in operation. Unplug the transformer. Replace the natural-stone "tower" into the water tank and cover the water tank with the natural-stone cover plate. Plug the cable of the water pump to the wire unit and connect the wire unit to the mains socket. The natural-stone water fountain is now ready for operation. Screw the plastic clip to the fixed cable holder to firmly clamp the cable. Disconnect the water pump wire cable from the transformer wire cable. Carefully remove the natural-stone cover plate from the natural-stone water tank. Take the natural-stone "tower" out of the water tank. Do not disconnect the hose connections between water pump and natural-stone "tower". Rotate the switch on the front side of the pump to adjust pumping rate: · · Rotate towards "MIN" for lower pumping rate Rotate towards "MAX" for higher pumping rate . from dust) may cause malfunction during operation; this may cause damages to the water pump!Replace dirty water by fresh distilled water once a week. Unplug the transformer. Disconnect the water pump wire cable from the transformer wire cable. Carefully remove the natural-stone cover plate from the natural-stone water tank. IRL Operating Instructions | Remove the enclosed screws of the cable holder at the upper rim zone of the water tank with a screwdriver and remove the plastic clip. Carefully remove the natural-stone "tower" connected to the water pump out of the water tank. Do not disconnect the hose connections between water pump and natural-stone "tower". Reset the natural-stone "tower" and the water pump to their original position in the water tank. Fasten the clip with the enclosed screws to the fixed part of the cable holder to firmly clamp the wire cable. Fill the water tank with distilled water to "MAX" mark. Replace the natural-stone cover plate to the water tank. Connect the water pump wire cable to the transformer wire cable and plug the transformer in a mains socket. [. . . ] Wycign uszkodzon arówk do przodu z uchwytu. Osadzi now arówk halogenow (12 V/10 W), korzystajc z mikkiej, niestrzpicej si ciereczki w uchwyt. Uwaga! Nigdy nie dotyka nowej arówki halogenowej golymi rkoma, poniewa moe to j uszkodzi! Wcisn i wkrci jednoczenie ostronie klosz ochronny ponownie w uchwyt na lamp. Wcisn wodoszczeln lamp mocno w plastikowy zacisk na przedniej stronie konstrukcji wodospadu, a do uslyszenia zablokowania na zapadk. [. . . ]