User manual KOMPERNASS KH 4077 STAND HALOGEN FLOODLIGHT

[. . . ] · Separate your Stand Halogen Floodlight from the mains supply immediately after use. The appliance is only completely switched off after having been unplugged. Danger of injuries · Always keep the Stand Halogen Floodlight beyond the reach of children Do not allow children to use it. Attention · Always remove the plug from electrical sockets before exchanging the halogen lamps. · Allow the halogen lamps to cool before removing them. · Switch the Stand Halogen Floodlight off only with the ON/OFF switch. [. . . ] Assembling the crossbeam on the telescopic stand. Insert the knurled screw d first of all through the hole in the distributer box s, then through the hole in the crossbeam y. Now assemble the crossbeam y and the distributor box s with the assistance of the knurled screw d on the telescopic stand u. Turn the knurled screw d until it is tight. Adjusting the height of the Stand Halogen Floodlight Loosen the fixing ring a by turning it in an anti-clockwise direction. Adjust the telescopic stand u to the desired height. Retighten the fixing ring a by turning it in a clockwise direction. To adjust the halogen floodlight e, use the knurled screw t, the fixing screw f and the floodlight lever w. Assembly Danger of electrical shock Never insert the plug into an electrical socket until the appliance has been completely assembled. Danger of burns Only touch the halogen lamps when they are in a switched-off and cooleddown condition. Never touch the lightbulb with bare hands, always use a clean and dry lint-free cloth. Opening up the pedestal base To set up the telescopic stand u, loosen the knurled screw, o. The pedestal base can now be opened out to the floor. Turn the knurled screw o until it is tight. -5- IB_KH4077_KO2561_UK. qxd 05. 03. 2007 11:52 Uhr Seite 6 KH4077 The horizontal position is adjusted in that the knurled screw t is loosened and, with the assistance of the floodlight lever w, it is placed in the desired position. Retighten the knurled screw t when the optimal position has been found. The vertical position is adjusted in that the fixing screw f is loosened and and, with the assistance of the floodlight lever w, it is placed in the desired position. Retighten the fixing screw, f when the optimal position has been found. During the adjustments always hold the floodlight lever w firmly. Do not use extension cables that are longer than 15 m. 3. Place the other ceramic end on the opposite retainer. Ensure that contact has been made on both sides. The retainers should now hold the halogen lamp securely, such that the halogen lamp can no longer move itself. Now close the glass cover g and replace and retighten the middle screw. [. . . ] Check the domestic fuses and, if necessary, renew them. The Floor Halogen Floodlight is possibly defect. Check the connecting lead and the power plug for damages. Have the Floor Halogen Floodlight checked over by specialists. Service DES Ltd Units 14-15 Bilston Industrial Estate Oxford Street Bilston WV14 7EG Tel. :0870/787-6177 Fax:0870/787-6168 e-mail: support. uk@kompernass. com Kompernass Service Ireland c/o Irish Connection 41 Harbour view Howth Co. [. . . ]