User manual KOMPERNASS KH 4098 LOW VOLTAGE HALOGEN SPOTLIGHT

[. . . ] Dispose of the appliance through an approved disposal centre or at your community waste facility. Observe the currently applicable regulations. In case of doubt, please contact your waste disposal centre. u Service DES Ltd Units 14-15 Bilston Industrial Estate Oxford Street Bilston WV14 7EG Tel. : 0870/787-6177 Fax: 0870/787-6168 e-mail: support. uk@kompernass. com Kompernass Service Ireland c/o Irish Connection 41 Harbour view Howth Co. [. . . ] The appliance would be irreparably damaged. · The flexible power cable of the transformer cannot be exchanged. Should the power cable be damaged, the transformer must be exchanged as a complete unit. · In exterior areas only use power sockets of the protection class IPX4. Description of the appliance Align the underwater lamps i with the assistance of the 5-stage pivoting device. Insert the power plug w into a wall power socket. In permanent installations we recommend that the transformer r is fastened down with the fixing holes. · · · q w e r t y u i o a Colour discs Power plug Power cable Transformer Connecting plug Coupling nut Cable Underwater lamp Lamp cover Outer race · Changing bulbs Intended use The low voltage Halogen spotlight is intended for the illumination of gardens or garden ponds. It is intended exclusively for private usage, not for commercial purposes! Commissioning Assembly 1. Insert the connecting plug t into the transformer r. Slide the coupling nut y onto the connecting plug t and screw it tight. Lay the slot of the coloured disc q on one of the two securing hooks of the underwater lamp i. Carefully press the coloured disc q down on the opposite side until it audibly engages. If you wish to exchange the coloured disc q, lightly press a securing hook outwards and at the same time press the coloured disc to the side. Placing the underwater lamps Ensure that a mains power socket is in the close vicinity. Place the underwater lamps i as desired. [. . . ] Insert the new halogen lamp into the housing and then press both of them back down again. NOTE: Ensure that the sealing ring is not displaced. Lay the lamp cover o onto the underwater lamp i. [. . . ]