User manual KOMPERNASS LERVIA KH 230 LAMINATING DEVICE

[. . . ] laminating thickness Laminating speed Roller temperature AC 230 V ~ 50 Hz 200 W 336 x 146 x 75 mm 1, 56 kg 230 mm 1, 0 mm 0, 3 m/Minute 120° C Safety information Setting up the laminating device: · The machine should not be set up in a damp area or in the vicinity of an air conditioning outlet in order to prevent the occurrence of surface leakages. · Ensure that the laminating device is set up upon a level, rigid and non-slip surface. There must be sufcient space behind the device to allow laminated lms to exit. Therefore it is important to ensure sufcient space between the rear-side of the device and any walls, objects, etc. . [. . . ] Switch on the device using the power supply switch (1). The green light designating "POWER" shines, showing that the device is switched on. Set the selector switch (2) on the front-side of the device to COLD. The yellow light designating "COLD" shines. Place the material to be laminated in a suitably sized lm pouch and feed it into the laminating device. The laminating can now take place automatically. Hot laminating Plug the laminating device's plug into the power supply socket. Switch on the device using the power supply switch (1). The green light designating "POWER" shines, showing that the device is switched on. Set the selector switch (2) on the upper cover to HOT. The motor starts to run and the device warms up to its operating temperature. The red light shines after a warm-up phase of 4­8 minutes; the rollers have now reached their operating temperature. Place the material to be laminated in a suitably sized lm pouch. Then feed the lm pouch into the laminating device's infeed opening. The laminating can now take place automatically. Ensure that the material being laminated lies directly on the fold of the lm pouch prior to the laminating. The lm pouch must be fed into the laminating device with the fold in front. In order to prevent creasing do not feed the lm pouch in with the open side facing into the laminating device. Thus the pocket should not be cut-off prior to being used. Pay attention to the pictograph on the infeed opening in order to ensure that the lm pouch is fed into the device correctly. [. . . ] Caution: Switch off the device and pull the plug out of the power supply prior to cleaning. The device must be completely dry prior to being used for laminating again!If the paper gets jammed and blocks the movement of the rollers because the paper can not be pulled out of the device, switch the machine off immediately and pull out the plug. Then contact your local laminating device representative or the local service partner. 3 Declaration of conformance We, Kompernaß Handelsgesellschaft mbH, Burgstr. [. . . ]