User manual KOMPERNASS PARKSIDE KH 3041 AIR STAPLER SET

[. . . ] Any other use or modification to the device shall be considered as improper use and could give rise to considerable risk of accident. We will not accept liability for loss or damage arising from improper use. The device is intended for private, domestic use only. Noise and vibration data: the measured values are determined in accordance with EN 12549:1999, EN ISO 4871. [. . . ] Do not use the device if you discover any defects. Never poke pointed and/or metal objects into the interior of the device. Never exceed the maximum allowable working air pressure of 7 bar. Use a pressure reducer to set the working air pressure. Never use oxygen or other combustible gas as the energy source. Keep your working area clean and well lit. Untidy or poorly lit working areas can lead to accidents. Keep children and other people away while you are operating the fastener driving tool. Distractions can cause you to lose control of the device. Remain alert at all times, watch what you are doing and always proceed with caution when working with the fastener driving tool. Do not use the fastener driving tool if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the fastener driving tool can lead to serious injury. The use of driven fasteners or accessories other than those recommended in the operating instructions could lead to you suffering an injury. NOtE: Operate the compressed air tacker only with cleaned, oiled compressed air and never exceed the maximum working air pressure at the device of A pressure reducer must be fitted to the compressor to regulate the working air pressure. Connect the other end of the compressed air hose to the (filter) / pressure reducer at the compressor. NOtE: Never place nails into the intermediate opening; this opening is intended for staples. Otherwise this could lead to a blockage in the driver and prevent the proper exit of the driven fastener. NOtE: Note that only staples with a length of 16 - 32 mm and nails with a length of 15 - 32 mm may be placed in the magazine. Load the magazine 6 of the compressed air tacker, as described in the section about "Loading the magazine". J Using the pressure reducer, set the correct working air pressure. J Ensure that the maximum working air pressure at the device of 7 bar is not exceeded. An increased working air pressure does not improve performance but only increases the consumption of compressed air and accelerates wear. [. . . ] This appliance is guaranteed for 3 years from the date of purchase. Please keep your receipt as proof of purchase. Contact your service centre by telephone in case of questions pertaining to the warranty. Your goods can be transmitted free of cost only in this manner. [. . . ]