User manual KONICA MINOLTA 1660E Reference Guide

[. . . ] QMS® 1660E Print System Reference 1800384-001B Trademarks The following are trademarks or registered trademarks of their respective owners. Those listed as registered are registered in the United States Patent and Trademark Office. Some trademarks are also registered in other countries. Other product names mentioned in this manual may be trademarks or registered trademarks of their respective owners. [. . . ] 1 Fan a stack of 500 sheets of paper, and align the paper on a flat surface. 6-12 QMS 1660E Print System Reference Media Input Options 2 Load the paper in three steps as follows: a b c Up to the bottom limit mark Halfway to the top limit mark Up to the top limit mark Top Limit 3 Ensure that the paper stack lies flat, does not exceed the top limit mark, and is positioned under the retaining clips. Retaining Clips Printer Options 6-13 Paper Output Ramp 4 Insert the cassette in the cassette installation slot. Push the cassette straight into the installation slot until it's firmly seated. 5 Adjust the media stop to fit the size paper you're using. The printer delivers your output print-side down to the output tray at the top of the printer. The media stop keeps the paper positioned correctly in the output tray. Paper Output Ramp The paper output ramp extends the QMS 1660E's output tray to accommodate 11. 7" x 19. 5"/297. 18 x 495. 30 mm media. Use the following instructions to install the paper output ramp: 1 2 Attach one of the Velcro pieces to the back of the media stopper. Set the paper output ramp on top of the printer output tray. 6-14 QMS 1660E Print System Reference Font and Security Cards 3 Attach the second piece of Velcro to the inside of the paper output ramp, making sure it is aligned with the first piece you attached. Slide the paper output ramp along the output tray until the two pieces of Velcro fit together snugly. 4 Velcro pieces v Caution: When removing the paper output ramp, carefully separate the two Velcro pieces so as not to damage the media stopper. Font and Security Cards The two PCMCIA (Personal Computer Memory Card International Association) card slots allow you to use the following options to increase the functionality of your printer: n n Font cards--Such as the HP ProCollection for the HP emulations on your printer Security card--To password-protect the printer configuration menu 6-15 Printer Options Font and Security Cards The card slots are located on the right side of the printer below the output tray. The printer supports up to two cards at once. You may insert any type of card in either slot. v Caution: Your printer supports only QMS PCMCIA cards. These cards are not backward compatible with previously released QMS printers, and cards for previous printers are not compatible with your printer. In addition, some cards may require that you add more memory to your printer. For a complete list of available font cards, contact your QMS vendor. v Caution: The printer must be off line (the Online/Offline indicator is off) before you insert or remove cards. Press the Online/Offline key once to take the printer off line. If you insert a font card in one of the card slots without taking the printer off line, the card will not be recognized. Using a Font Card Use the following procedure to use a font card on your printer. If your printer has a hard disk, you can install the font information from the card onto your hard disk. See "Installing an Optional Font" later in this chapter for instructions. 1 If you are using an HP ProCollection font card, turn off the printer. Otherwise, press the Online/Offline key to take the printer off line. (The Online/Offline indicator should be off. ) 6-16 QMS 1660E Print System Reference Font and Security Cards 2 Insert the font card. You can use either slot, but the card must be inserted with the QMS label side facing up. You should feel the card snap into place. 3 Depending on the type of card you are installing, either turn on the printer again or press the Online/Offline key to put the printer back on line. The fonts are now ready to be used. » Note: If you're using a font card, you should also make sure that the printer driver you have installed for each application supports the fonts on the card. [. . . ] ROM stores read-only data, RAM represents temporary storage, and hard disks hold information on a more permanent basis. See also hard disk, RAM, ROM, spool. System Administrator The person in charge of managing a network; also called a network administrator. Thin-Wire Ethernet Cable Coaxial cable 0. 2" (5 mm) in diameter that can connect network stations over a distance of 607 feet (185 meters) apart. See also coaxial cable and 10Base2. Timeout The expiration of a predefined interval, which triggers some action such as a disconnection that occurs following 30 seconds without any data activity (in a 30-second, no-activity timeout). Timeout also refers to the length or existence of such an interval. Toner A dry, powdered substance capable of being attracted to electrically charged areas on a photosensitive revolving drum. [. . . ]