User manual KONICA MINOLTA 7013 PSC

[. . . ] Print Server Card For Novell NetWare¨, AppleTalk, and TCP/IP Networks Owner's Manual Ethernet and Token Ring Models Preface-1 D76-9A130-60 Important No title to or ownership of the software described in this document or any of its parts, including patents, copyrights and trade secrets, is transferred to customers. It is against the law to decipher, de-compile, or develop source code for the software described in this document, or knowingly allow others to do so. There are no representations or warranties regarding the contents of this document. Information in this document is subject to change without notice and does not represent a commitment. [. . . ] This can be done with MAP if you have a IPX connection on your network, or with AppleTalk NIManage utility program if there is an Apple Macintosh on the network. Follow the instructions for these programs which are documented elsewhere. If you cannot use these programs, you can use either the ARP procedure, or the BOOTPL32 program. Install the Print Server Card in your printer. Keep the status sheet handy for the Ethernet (MAC) address. It should show that TCP/IP is enabled but that the Protocol address is not configured. If the unit already has an IP address, these procedures will not work. However, you can Telnet or use the HTML pages accessed by MAP or Web Browser to change the IP parameters. TCP/IP Configuration-5 7. 1. 2. 3 Assigning IP Address with ARP The Print Server Card must be on the same network segment as the workstation that you are using to configure it. The TCP/IP stack must be installed and operating. You can use BOOTPL32 to configure the IP address instead of ARP. At the command prompt enter: ping [any valid IP address on your network - not the print server]. After the response, enter: arp -s [IP address of the Print Server Card] [MAC Address of the Print Server Card]. ping [IP address of the Print Server Card]. Recycle the power on the printer, or let the Print Server Card reset itself. The Print Server Card will produce a status page that should include the entered IP address. When the Print Server Card is up again, at the command prompt, enter: ping [IP address of Print Server Card] (continue until you get a reply). You must use the Telnet facility, (Section 7. 5 Running Telnet, ) to enter the other IP parameters. 7. 1. 2. 4 Assigning IP Address with BOOTPL32 You may provide the IP address and other IP parameters to the printer Print Server Card on 32 Bit TCP/IP Stack (Windows NT & Windows 95/98) using the BOOTPL32. exe program. You will have to store the BOOTPL32. exe file in the Windows directory. The BOOTPL32. exe program will not work if the Windows PC is an active DHCP Server. TCP/IP Configuration-6 This program uses the BOOTP protocol. The Print Server Card must be on the same network segment as the workstation that you are using to configure it. The TCP/IP stack must be installed and operating. [. . . ] " ::= { dpitcp 22 } enDataAuth OBJECT-TYPE SYNTAX DisplayString (SIZE(0. . 8)) ACCESS read-write STATUS mandatory DESCRIPTION "This variable specifies whether or not the Email Print data authentication function is enabled. Writable Values are: enabled disabled in upper case or lower case. Stored values are: ENABLED DISABLED Note that this function may not be supported in all units And therefore may not be in effect even if it is 'enabled'. " ::= { dpitcp 23 } enAdminNotfy OBJECT-TYPE SYNTAX DisplayString (SIZE(0. . 8)) ACCESS read-write STATUS mandatory DESCRIPTION "This variable specifies whether or not the Email Notification to the administrator function is enabled. [. . . ]