User manual KONICA MINOLTA FREEDOM FAMILY ZOOM II, FREEDOM ACTION ZOOM 60

[. . . ] â· The camera is dropped or subjected to an impact in which the interior is exposed. â· The product emits a strange smell, heat, or smoke. Electric shock may occur if a high voltage circuit inside the camera is touched. Take your camera to a Minolta Service Facility when repairs are required. [. . . ] Remove the old battery from the battery chamber + end first (C). If blinks in the data panel with the other indicators, the battery will need to be replaced soon. If all indicators blink in the data panel or the camera will not function with a fresh battery, remove the battery, wait a few seconds, then reinsert it. To save power, your camera will shut down if it is not operated for more than 3 minutes. Turn the camera off and then back on to restore power. When film is in the camera, turn the camera off before removing the battery. Insert a new battery immediately after removing the old battery. If these steps are not followed, your camera may advance the film several frames, and reset the frame counter to one. Do not use Polaroid instant films in this camera. Make sure is displayed in the frame counter, then slide the back-cover release down to open the back cover (D). Position the film between the film guide rails or a film transport error may occur (G). â· If the film tip extends beyond the film-leader index, gently push the excess film back into the film cartridge. Looking through the viewfider, center your subject in the focus frame (H). When taking vertical pictures, hold the camera so the flash is on top. Press the shutter-release button with a slow steady squeeze to take the picture (J). Wait for the lamp to glow brightly, then take the picture. Your camera will not take a picture until the flash is charged. Subjects outside the focus frame may not be in focus. Without lifting your finger, recompose your picture (L). Press the shutter-release button all the way down to take the picture. [. . . ] Frame your subject in the viewfinder, then press the shutter-release button all the way down to take picture. Your camera automatically rewinds the film after the last exposure is taken. If the frame counter shows anything other than when the rewind motor stops, DO NOTOPEN THE BACK COVER. Replace the batteries, press the manual rewind button, and wait until appears and blinks in the data panel before opening the back cover. [. . . ]